We will reply to your message within an hour.
Use these guides to position a rope.
Clamp around a pipe or tube to guide rope.
Accommodate ties in any direction with these rings that swivel all the way around.
The ring pivots 90° or 180° to secure loads in various directions.
Dimples hold the base tight to prevent it from swiveling.
These rings mount flush and fold down when not in use to eliminate obstructions.
Also known as pad eyes, these rigid rings provide a strong, fixed anchor point.
Accommodate ties in any direction with these rings that swivel all the way around and pivot 180°.
The ring pivots 180° to secure loads in various directions. Also known as lashing rings.
Use these rings to make a temporary anchor point on ferrous metal surfaces.
Large holes in the base allow adhesive to flow through.
Adhesive on the back holds these rings in place.
Press rope into the gripping body of these cleats for a quick hold.
Wind rope around these cleats for a secure hold.
Two rotating cams pinch and hold rope as you pull it through to provide a temporary hold.
Also known as footman's loops, use these guides to prevent webbing from twisting, or as anchor points in tie-down applications.
No need for drilling or welding—these guides mount with adhesive.
Sew webbing onto these plates for a permanent anchor point or run webbing through to use them as guides.
Also known as bridle rings, routing rings have an open-eye design that allows you to quickly install wire and cable.
Anchor these ringbolts where you need them, then remove the ring when not in use. Once installed, the mounting bolt stays in place. Insert the ring by threading into the mounting bolt; remove by unthreading it.
Mount these ringbolts into a threaded hole, or use the nut for through-hole mounting. The pivoting ring allows material to move freely.