Free of crevices where bacteria can grow, these mounts have an extremely smooth finish, rounded edges, and a covered stud. A silicone seal at the base of the thread cover keeps contaminants out. The seal is made with chemical additives, so you can find it with an X-ray machine if it falls into your line. Mounts are certified by 3-A, EHEDG, and USDA to meet sanitary design standards. You can also bolt them down so machines don’t creep across the floor or tip over. The rubber cushion on the bottom reduces vibration to extend your machine’s life. In addition, the ball-and-socket joint in the base swivels to compensate for slightly sloped and pitted floors. For mounting versatility, you can install these mounts in either threaded holes or unthreaded through holes at the bottom of equipment.

With an extremely smooth finish, rounded edges, and a covered stud, these mounts are free of crevices where bacteria can grow. A silicone seal at the base of the thread cover keeps contaminants out. The seal is made with chemical additives, so you can find it with an X-ray machine if it falls into your line. To level equipment on sloped floors, insert these mounts into a hole on the bottom of your equipment, and then weld the seam to seal the connection. Once you've adjusted the stud to your desired height and angle, weld the stud to the base.

304 Stainless Steel Base—The choice for most wet locations, these mounts can withstand repeated washdowns without corroding. However, they won't hold up to cleaning solutions that contain harsh chemicals like 316 stainless steel can.

Rubber Cushion—A cushion under the base grips surfaces so vibrating equipment doesn't slide. It also protects floors from scrapes and gouges.