The rubber backing cushions the abrasive to prevent gouging your work surface.

Aggressively remove material from hard, non-metallic surfaces such as ceramics, brick, stone, concrete, glass, and composites like carbon fiber and fiberglass. Harder than aluminum oxide, silicon carbide cuts effectively on brittle and abrasive materials where softer abrasives wear down quickly. The coarse 24 grit cuts fast for rough shaping, stock removal, and surface preparation.

Everything you need to use your oscillating tool as a sander—great for smaller jobs that a large sander can’t accommodate. Swap out sheets on the backup pads quickly thanks to the hook and loop. These can be used with Starlock-compatible oscillating tools.

The abrasive-embedded mesh construction gives you more control over sanding pressure, creating finer and more consistent finishes. These pads sand inside pipes and tubes as well as on an angle to reach into corners and slots. A shank adapter is required (sold separately).

The ceramic alumina abrasive on these pads is sharp and dense enough to shape hard metals such as stainless steel, nickel, and iron without dulling quickly. They’re often used to sand inside pipes and tubes, or to sand at an angle when reaching into corners and slots. The abrasive material on these pads continuously fractures to produce new, sharp cutting edges. They sand faster and last longer than aluminum oxide but require more force to abrade properly. A shank adapter (sold separately) is required.

Sand inside pipes, tubes, and hard to reach corners with these pads. A shank adapter is required (sold separately). The most common abrasive material, aluminum oxide is hard enough to sand steel and wood.