We will reply to your message within an hour.
More
18-8 stainless steel screws have good chemical resistance.
More corrosion resistant than 18-8 stainless steel screws, these have excellent resistance to chemicals and salt water.
Because these steel screws cut threads into drilled holes as they’re turned, they require less driving torque and cause less stress on material than thread-forming screws. Also known as trim-head deck screws, they have a small flat head and slender shank to reduce the risk of splitting boards.
Thread-forming screws press threads into drilled holes for a tight, vibration-resistant assembly.
Threads change direction to cut into composites and push material back into the hole to prevent distorting the surface around the hole.
The neoprene-backed washer seals out contaminants.
Screws are beveled under the head for use in countersunk holes.
These Phillips head screws have a decorative rounded top that provides a finished appearance.
These steel screws are zinc plated to resist corrosion in wet environments.
These 316 stainless steel screws have excellent resistance to chemicals and salt water.
With a low-profile rounded head that’s flanged to sit flush for a finished appearance, these screws press threads into wood on cabinets, trim, molding, and light duty framing.
These steel screws have a black-oxide finish to resist corrosion in dry environments.
These steel screws are available with corrosion-resistant finishes.
The S-shaped drive can be installed with a standard slotted driver, but requires a special tool for removal.
A flange under the head distributes holding pressure and reduces the risk of crushing thin metal.
A free-rotating, permanently attached washer distributes holding pressure over a wider area than a flange and remains stationary to prevent scratching the material surface as you tighten the screw.
A decorative rounded top provides a finished appearance.
These screws have a free-rotating, permanently attached washer that remains stationary while tightening to prevent bunching while attaching tarps and other fabric to metal.
These square-drive screws have a drill point that powers through drywall and into metal studs up to 0.105" thick. Heads are one-third smaller than those of other drywall screws.
A drill point powers through drywall and into metal studs up to 0.105" thick. Heads are one-third smaller than those of other drywall screws.
With a square-drive head, these screws attach drywall to metal studs up to 0.036" thick. The head is one-third smaller than other drywall screws.
These screws have a head that's one-third smaller than other drywall screws. Use them to attach drywall to metal studs up to 0.036" thick.
Cutting wings under the head allow plastic to expand and contract without cracking. A washer made from aluminum and rubber bonded to steel adds a watertight seal.