Measure the amount of light oil that flows through these totalizers. They use positive displacement, so they measure flow by passing specific volumes of liquid through a chamber. Their total can be reset. Manually or automatically turn them on, and they automatically shut down 40 seconds after flow stops. Their mounting orientation won’t affect their ability to measure flow correctly. Install these totalizers directly inline with your pipe system using the fittings on each end. The fittings are 316 stainless steel, so they resist impact better than plastic fittings.

These totalizers are calibrated with water. You can recalibrate them in the field to other liquids, pipe, and operating conditions.

Track batches and the total amount of gasoline, diesel fuel, and kerosene passing through your system. The batch total is resettable, but you can't reset the cumulative total. They automatically reset the batch to zero when they reach the maximum. They measure flow volume by counting how many times their turbine turns as liquid flows through. To avoid clogging the turbine and other damage to these totalizers, use them only with clean, low-viscosity liquids. They’re accurate in any mounting orientation. Mount them inline with your pipe system.

These totalizers are calibrated with diesel fuel. You can use them with other liquids, but they may not measure accurately if the liquid’s viscosity differs from diesel fuel.

The digital display on these totalizers makes it easy to check the total amount of high-temperature liquid—up to 200° F—passing through your system. They measure flow volume by counting how many times their turbine turns as liquid passes through. To avoid clogging the turbine and other damage to these totalizers, use them only with clean, low-viscosity liquids. The batch total can be reset after each metering application. They come set for batch totalization, but you can disable the reset function to operate as a cumulative totalizer. They measure flow accurately no matter the mounting orientation. Rated NEMA 4X and IP65, they seal out dust and protect against washdowns and corrosion.

These totalizers are calibrated with water. You can use them with other liquids, but they may not measure accurately if the liquid’s viscosity differs from water.

Check the flow rate of liquids up to 200° F from an easy-to-read digital display instead of a scale or dial. These flowmeters measure flow by counting how many times their turbine turns as liquid flows through. To avoid clogging the turbine and other damage to these flowmeters, use them only with clean, low-viscosity liquids. Mount them inline with your pipe system. Their fittings are polypropylene, which works with a wide range of chemicals. NEMA and IP rated, these flowmeters stand up to dust, weather, corrosion, and water from washdowns.

These flowmeters are calibrated with water but can be used with other liquids. If you’re using these with a liquid other than water, you’ll need to calculate the flow rate by multiplying the number shown on the scale by the specific-gravity conversion factor for your liquid.

Often used to pinpoint flow issues, these flowmeters clamp onto pipe, so you can spot-check the flow rate at different points without disassembling your system. They measure by tracking the time it takes for ultrasonic waves to pass through your liquid, so they don’t need to come into contact with your liquid. As a result, they can be used with a wider range of liquids than other flowmeters.

Use these flowmeter/totalizers to measure both the flow rate and total flow volume of oil, gasoline, diesel fuel, and kerosene. They count how many times their turbine turns as liquid passes through them to measure flow. To avoid clogging the turbine and other damage to the sensor, use them only with clean, low-viscosity liquids. You can reset the batch total, but you can't reset the cumulative total. Mount them directly inline with your piping system. They measure flow correctly no matter the mounting orientation. Rated NEMA 4 and IP65, they seal out dust and protect against washdowns.

These flowmeter/totalizers are calibrated with either water or solvent. You can recalibrate them in the field to other liquids, pipe, and operating conditions.