Housing is plastic.

Press the side of the gauge tip against an object to record the amount of tension required to move it.

Measure the tension of wire or cable.

Measure the tension of wire and filament without pausing your operation.

Use the included Windows-compatible software to upload measurement data.

Read tension and compression measurements with a glance—these gauges have three color-coded indicator lights to show you if a part is at your desired force. Red means the force is too high, orange means too low, and green is just right.

Measure tension force as well as weight. Also known as dynamometers.

Good for gripping most shapes and materials.

Hold fine wire and filament.

Often used on packaging films, food seals, and gloves, these tools test the puncture strength of thin materials.

Measure the force needed to carry out tasks in your facility, such as pushing carts, pulling pallet trucks, or lifting containers.

Check that your products have the right balance of grip and slip. For quality control, these testers are commonly used to measure friction generated by packaging materials such as plastic film and cardboard.

Determine if an adhesive or an epoxy creates a strong enough bond on a surface.

Calibrate these sensors to your desired capacity to measure tension, compression, or both. Also known as load cells, they measure and track the forces of your equipment by converting them into electrical signals.

Also known as junction and summing boxes, these hubs combine the measurements of multiple tension and compression force sensors together.

Monitor torque as you apply it—these testers mount between your torque tool and your fastener.

Measure the force of hand and non-impact electric torque screwdrivers to keep fasteners from failing due to under or overtightening.

Place your tool and the included square drive connector on the tester and turn.

Finger-tighten the three-jaw chuck onto a torque wrench or screwdriver, then twist either the gauge or tool to check the tool’s accuracy.

A dial shows how torque measurements change as you turn the driver. Use these tools to fasten to a specific torque, determine fastener torque specifications, and identify the torque required to loosen tightened fasteners.

A green light and a beep alert you when you've reached 90% of your set torque, and a steady tone sounds once you've hit your target. Set your torque in cNm, cm-Kg, or in.-lbs. and quickly check the LCD for real-time measurements along the way. A red light warns if you begin to overtighten.

A main pointer on the dial shows torque as it’s being applied and a memory pointer indicates the maximum torque reached.

Trust the precision of your measurements—these wrenches are accurate to ±2%.

Trust the precision of your measurements—these wrenches are accurate to ±1%.

These wrenches have an accuracy of ±2.0%.

Check the tension of your machine’s flat, timing, or V-belt—no matter its width. These gauges use ultrasonic sound waves to take noncontact readings.