An alternative to heat transfer compounds, these soft, flexible pads transfer heat from a source to a heat sink.

Soft and easy to install, this insulation restricts absorption of water, air, and gas. It is often used on cold and hot water lines and refrigeration lines.

Less flexible than rubber foam, this insulation restricts absorption of water, air, and gas. It is typically used in plumbing applications

This common insulation material is typically used on hot and cold water lines and in process piping.

Thinner than most rigid insulation for furnaces and other high-heat applications, these millboard sheets are also used for gasket fabrication.

The most common of our flexible high-temperature sheets, these are used to insulate furnaces.

Wet these rigid sheets and they become formable. They can be molded multiple times until exposed to heat, which causes them to become rigid again.

Designed for fluctuating, high-temperature applications, these semi-rigid sheets are typically used in furnaces and fire protection applications. They experience very little shrinkage at high temperatures, but the brittle material can be somewhat difficult to work with.

Typically used in ovens and furnaces, these are the most efficient of our rigid high-temperature insulation sheets. Please note that they require special care when installing since the crumbly material is difficult to work with and will crack easily. Sheets lose strength over time and are intended to be installed behind another facing or insulation material.

Even when subjected to heavy compression, these rigid polyimide sheets won't crack.

Commonly used in furnaces and engine compartments, these flexible silica fiber sheets resist corrosive acids.

Made of rugged PVC foam, these rigid sheets absorb impact and restrict the absorption of water, air, and gas. Use in applications with operating temperatures below 32° F.

Wrap rectangular and round ductwork with this flexible insulation.

Insulate rectangular ductwork.

Typically used as duct wrap, these flexible sheets consist of polyethylene bubbles covered with aluminum polyester foil that prevent 96% of heat from radiating into or away from duct. Use on rectangular and round ductwork.

Also known as thermal pads and thermal interface pads, these heat-dissipating pads pull heat away from electronic components.