Designed to stand up to heavy use, these wheels remove more material than our general purpose grinding wheels.

The special shapes of these wheels provide more clearance than typical straight wheels.

Typically used with cylindrical, surface, and ID grinders, these wheels are specially designed to grind the inside diameter of workpieces.

Bonded without any wax or rubber filler, these wheels resist material buildup. They are also known as Type 27 wheels, raised-hub wheels, and grinding discs.

The flexible backing on these wheels conforms to curved and rough surfaces.

A large grinding surface, combined with a thick layer of rough abrasive removes more material than other wheels. They are also known as Type 11 wheels, flared-cup wheels, snagging wheels, and cup stones.

Use these wheels for heavy material removal in one spot or along a weld seam. They are also known as Type 1 wheels and snagging wheels.

The abrasive grains in these bits are blended with rubber, which cushions during grinding to produce a smoother surface texture than other bits with similar grits.

Use bits in any drill chuck that accepts a 1/4" hex shank.

Each set contains a selection of our most popular grinding bits.

Overlapping abrasive flaps bonded to a backing plate provide consistent material removal and even finishes.

Set at an angle and widely spaced, the overlapping abrasive flaps reach into corners.

The flaps have an abrasive to remove material and a lubricant that minimizes heat to reduce discoloration of the work surface.

The premium abrasive stays sharp longer.

Debur, clean, and blend faster than other nylon mesh discs.

The abrasive-embedded nylon mesh construction gives you more control over sanding pressure.

The heavy duty construction provides more support than standard discs for heavy material removal.

A coating prevents dust and debris from building up on the abrasive surface.

Holes in the disc let you see the surface you’re sanding.

A coating prevents dust and debris from building up on the abrasive surface.

Holes allow dust removal when used with a vacuum sander.

Holes allow dust removal when used with a vacuum sander.

The thick, abrasive-embedded nylon mesh construction gives you maximum control over sanding pressure.

The premium abrasive lasts longer as well as cuts faster and produces a more consistent finish than standard hook and loop discs.

The premium abrasive lasts longer as well as cuts faster and produces a more consistent finish than standard hook and loop discs.

The cushioned construction gives you more control over sanding pressure, creating finer and more consistent finishes.

Also known as Type 27, raised-hub, and depressed-center cutoff wheels, these wheels outperform Type 1 wheels when making flush cuts in metal.

Made of premium grade abrasives, these wheels are strong and thick for making notches in aluminum, iron, stainless steel, and steel.

Also known as Type 27, raised-hub, and depressed-center cutoff wheels, these wheels outperform Type 1 wheels when making flush cuts.

Also known as Type 27, raised-hub, and depressed-center cutoff wheels, these wheels outperform Type 1 wheels when making flush cuts.

Run these high-density aluminum oxide wheels at higher speeds than standard cutoff wheels to make quick cuts in aluminum, iron, stainless steel, and steel.

These wheels are designed to cut stainless steel. They are reinforced with a layer fiberglass mesh.

Use these wheels to cut through metal such as aluminum, iron, stainless steel, and steel.

Use these wheels to cut through metal such as iron and steel. They are reinforced with a layer of fiberglass mesh.

These wheels are thinner than standard bench-top cutoff saw wheels, so they cut through aluminum, iron, stainless steel, and steel more quickly.

These wheels are reinforced with fiberglass mesh and designed to last longer than standard wheels when cutting ductile cast iron.

Use these clog-resistant wheels to make quick cuts in soft metal such as aluminum, brass, and copper.