The head on these mallets is loaded with metal shot for added weight and a controlled impact with minimal rebound. Use them to drive chisels and strike work without damaging its surface. To avoid marring, choose a mallet with a face that's softer than your workpiece. Lighter weight mallets are good for tapping work into place and driving a chisel to make small cuts. Use heavier weight mallets when assembling joints, dislodging stuck parts, and making aggressive cuts with a chisel. Longer mallets allow for more powerful swings. All have a textured or ribbed grip for slip resistance.

Mallets with two face materials can be used for a wider range of applications than other mallets.

Plastic faces are softer than metal faces, so they're good for striking plastic, wood, and sheet metal. All have a face hardness rating for comparing their hardness with other plastic faces. Hard faces have a hardness similar to that of a bowling ball. Fiberglass handles combine high strength with good vibration resistance.

Replace faces when they become worn rather than replacing the entire tool. These mallets are suitable for driving chisels and striking work without damaging its surface. Choose a mallet with a face that's softer than your workpiece to avoid marring it when tapping or striking. Lighter weight mallets are good for tapping work into place and driving a chisel to make small cuts. Use heavier weight mallets when assembling joints, dislodging stuck parts, and making aggressive cuts with a chisel. Longer mallets allow for more powerful swings.

Copper faces are for use on brass, copper, aluminum, and steel.Hickory and ash handles resist vibration.

The face and head are made of aluminum-bronze that is Factory Mutual approved, so these tools inhibit sparking, resist corrosion, and are nonmagnetic. They satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present. Use the domed end of the head for forming soft metal, rounding off edges, and closing rivets. The flat striking face is for driving nails, pins, punches, and chisels. All have a textured grip for slip resistance. For replacement handles, see Fiberglass Hammer Handles.

Warning: Do not use these tools in direct contact with acetylene.