We will reply to your message within an hour.
Bolts are spring-loaded to stay latched until you activate the pull.
Pull the chain-grip to unlatch hard-to-reach doors and panels.
The spring-loaded bolt stays latched until you pull it back—slide the bolt and drop the knob into the notch to secure.
The spring-loaded bolt stays latched until you pull it back.
A paddle handle activates the top and bottom spring-loaded latching points to secure large cabinet doors.
These latches are typically used to secure hoods and covers.
With a spring-loaded handle, these hold tighter than other turn-to-open draw latches and compensate for slight misalignment.
Lift and turn the handle 180° to open and close this lock.
Lift and turn the handle 180° to open and close these latches. Add a padlock to secure.
With just a push, these latches firmly grip the strike bolt on your door to hold it shut. They come with a handle attached to the latch—no need to install a cable or rod.
These spring-loaded latches withstand vibration, rattling, and shaking better than other face-mount push-to-close latches. Quickly push the latches closed to secure doors.
These latches snap together to secure doors. They have a return spring to snap tight with a push and release with a pull.
A T-handle makes these spring plungers easy to grip.
A quarter turn of the handle locks these plungers in the retracted position. The T-handle is easy to grip.
An L-handle takes up less space than a T-handle.
A smooth ball handle is easy to grip and won't catch on other parts.
A quarter turn of the handle locks these plungers in the retracted position. The smooth ball handle is easy to grip and won't catch on other parts.
Add a knob or handle to the threaded shank.
Lock the nose into the retracted position by pulling the handle and rotating it 90°.
Lock the nose into the retracted position by pulling the ring and rotating it 90°.
Retract the nose by pulling the knob.
Lock the nose into the retracted position by pulling the knob and rotating it 90°.
Quickly align, join, or hold machine components in place in food, pharmaceutical, and other sanitary environments. Pulling the plunger knob and twisting it 90° will lock the nose into its retracted position.
The ring allows you to attach these spring plungers to a lanyard.
Use the lanyard as a tether to secure the spring plunger to machinery and prevent accidental drops.
Install by hand or with a hex key in low-clearance applications.
Thread onto machinery or attach a knob or handle to the threaded spindle.
Lock the nose into the retracted position by pulling and rotating the knob.
Two holes in the plate allow these plungers to be mounted to a flat surface.
Use an arbor press or similar pressure tool to install these spring plungers into a panel.
Lock the nose in the retracted position by pulling the knob and rotating it 90°.
Insert the nose into a panel; then thread on the nut and tighten using an installation wrench.
These hinges with holes are spring loaded—pull the handle to retract the pin and disconnect a door; release the handle and the pin snaps back.
These hinges without holes are spring loaded—pull the handle to retract the pin and disconnect a door; release the handle and the pin snaps back.
To make reconnecting doors easier than other pull release quick disconnect hinges, these have a keeper that holds the pin in a retracted position.
A keeper holds the pin in a retracted position to make reconnecting doors easier than other pull-release quick-disconnect hinges.
Remove the ring to pull out the pin.
To retract the pin and disconnect a door, squeeze the hinge handles together. Release the handles and the pin snaps back.
Squeeze the hinge handles together to retract the pin and disconnect a door; release the handles and the pin snaps back.