Pierce the insulation of wire without stripping it to make quick connections that are also sealed to keep out water. These splices have termination buttons on each end, so you can make independent connections on both sides. Since you connect each end independently, they’re often used as a disconnect point on equipment that you’ll be moving around. To install these splices, use a pair of pliers to press down on the button until it clicks.

On 2-wire splices, each button comes in one of three colors that correspond with wire gauge, making it easy to match your wire to the right connector.

4-wire splices have two entry points on both ends for twice as many independent connections as 2-wire splices.

For technical drawings and 3-D models, click on a part number.

Join wires and cables in some of the dirtiest and wettest locations—from paper mills to marine environments—without special tools. With a nylon body and gasketed end caps, these splices are IP68 rated to seal out dust and water even if briefly submersed. To install, insert wire into either side, tighten the screws with a slotted screwdriver, and twist on the end caps to seal. They have multiple terminals, so you can repair, extend, and reconfigure cables with multiple wires.

For technical drawings and 3-D models, click on a part number.

Rated IP67, these connectors create a dust- and watertight seal where they fit into the housing of power supplies, appliances, and other electronic devices. Instead of hardwiring your devices, these connectors let you plug in a standard IEC power cord and turn the power on and off with a built-in switch. Wire these connectors using the quick-disconnect terminals; they slide together with matching terminals on your wiring for a secure hold that's also easy to pull apart to make repairs. The terminals are on the back of the connector, so the wiring stays inside your device.

To protect your devices, these connectors have a thermal circuit breaker that uses the excess heat when there’s overcurrent to trip the breaker and cut power. If there’s a short circuit, the breakers can safely stop up to a 2,000-Amp breakthrough current. These connectors also have Class I shock protection, so they’re insulated and have a protective ground.

These connectors meet UL 94 V-0, which means they self-extinguish within 10 seconds if they catch fire, and won’t spread the fire by dripping. They’re also UL and C-UL recognized components, and CE and ENEC marked, so they meet stringent safety standards.

For technical drawings and 3-D models, click on a part number.