Extra-thick walls provide more protection against abrasion and tears than standard high-shrink-ratio tubing. This tubing shrinks down to 1/6th of its original ID, so it creates a tight seal over irregularly shaped objects.

The smallest heat-shrink tubing we offer, this tubing protects wire with a 0.017" and smaller diameter.

Access connections more easily than with standard heat-shrink tubing. Make a small slit in this tubing to peel it away.

This tubing shrinks down to a quarter of its original ID, so it creates a tight seal over irregularly shaped objects. It withstands up to 500° F.

With thin walls, this tubing shrinks faster than other high-temperature tubing. It withstands up to 500° F.

Create a water-resistant seal—this tubing has an adhesive lining that melts when the tubing is heated and bonds to the underlying surface.

This PTFE tubing withstands temperatures up to 450° F and has an inner lining that creates a water-resistant seal when heated.

Use this tubing where wire and cable may be exposed to chemicals, oil, and acids.

Often used to bundle batteries, capacitors, and other electronics, this tubing tightly conforms to objects, similar to shrink wrap. It has excellent resistance to chemicals, oil, and acids.

Made of woven polyolefin/polyester fabric, this tubing has excellent abrasion resistance so it can be dragged over rough surfaces without damage.

Protect light bulbs, capacitors, and other electronics—this FEP tubing adds a tear- and cut-resistant layer that even contains shattered glass if the bulb breaks.

Approved for contact with food, this tubing is FDA Compliant 21 CFR 177.1330.

Even with walls as thin as tracing paper, this PET plastic tubing withstands tears and nicks. Thanks to its thin walls, it shrinks down in seconds instead of minutes and at lower temperatures than PVDF and FEP plastic tubing.

Made of PVDF, this tubing has excellent cut and abrasion resistance. It has a flame-retardant additive that resists combustion and minimizes the spread of flames.

A different shrink ratio on each end allows this tubing to fit over cable assemblies and wire harnesses with large connections, or around connectors with a 90° elbow.

Protect wire and cable without disconnecting them from an assembly. For a water-resistant seal, this tubing has an adhesive lining that melts when heated to bond it to the underlying surface.

Maintain a supply of tubing in a variety of sizes that withstand abrasion, moisture, and chemicals.

Also known as breakout boots, these splitters insulate and seal the point where wire splits off from cable, or where cables exit from conduit.

With a spiral-wound core, these end caps form a permanent seal on the end of your crimped wire or cable without heat or tools.