Turn the dial to control the percentage of time that these heaters cycle on, from 5% to 100%. Commonly used to thaw pipes, prevent valves from freezing, and heat beakers and flasks in labs, they're good for temporary and occasional use where rapid heating is required but precise temperature control is not.

Wrap the flexible heating element around small-diameter pipes and tubes or pack it into tight spaces.

With a cable that supplies the same wattage along the entire length, these heaters remain consistent regardless of the surrounding temperature. All require a temperature switch or controller to regulate heat output.

Also known as self-regulating heat cable, these heaters automatically adjust heat output at different points along their length to account for differences in environmental temperature.

Keep liquid in your pipes from freezing, maintain a specific viscosity, and prevent condensation in cold areas.

Install these heaters into threaded container openings or pipe couplings to quickly and efficiently heat liquid through direct contact.

Bolt the flange to a matching flange welded on a container wall.

Hook these heaters on the side of small drums and pails.

Install these heaters into threaded container openings or pipe couplings to quickly and efficiently heat liquid through direct contact. The heating element is Incoloy for excellent resistance to harsh chemicals.

For applications requiring high heat over long periods of time, these aluminized steel heaters warm up faster and are more durable than silicone rubber heaters.

Heaters are fiberglass-reinforced silicone rubber.

Strap these heaters around cylinders to keep gas flowing when the temperature drops. Also known as heat blankets, they heat cylinders from the outside, safely warming liquefied gas enough so that it can vaporize.

These ETL-listed heaters keep containers warm in areas where hazardous material is present. Also known as heat blankets, they surround drums and totes to heat them up quickly.

A fan cools water as it moves through the tubes.

For greater cooling capacity and higher flow rates than other heat sinks for oil, these have a large fan.

Shaped like a large flashlight, use these wands to loosen stuck nuts, heat bearings, and repair dents.