Cut perfectly round holes in a variety of diameters. With variable-set teeth, the saws make quick cuts through wood, sheet metal, and other materials with minimal vibration. Also known as bimetal hole saws, they have high-speed steel teeth and a steel body. Often used to remove more material than drill bits, these saws are helpful for jobs such as creating cutouts for doorknobs or cables. Attach them to a drill or drill press with the included arbors.

Quick-change hole saw arbors use a simple push-and-turn motion to attach and detach the saw. This makes it easy to quickly change sizes, instead of having to screw a hole saw on and off.

Quick-release pilot drill bits are easy to remove—just pull them out of your saw without any special tools.

Quickly connect these saws to your drill or drill press with the built-in arbor. Saws have high-speed steel teeth for cutting wood, plastic, and metal. A _1/4" diameter pilot drill is included.

Cut holes in wood and plastic five times faster than standard hole saws and with fewer blade changes. The teeth on these saws are shaped to power through not only wood, particleboard, and plastic but also drywall, plaster, and even masonry. Made of carbide, the teeth are the hardest in our hole saw offering, so they stay sharp up to twice as long as high-speed steel teeth.

To attach these saws to a drill or drill press, you'll need an arbor with a pilot drill bit (sold separately). If you're using an arbor you already have, make sure the pilot drill bit is at least 3 _5/8" long.

Quick-change arbors don’t require an L-key or screwdriver to swap out a dull pilot drill bit—just pull back on the release collar.

The diamond-grit edge on these hole saws cuts more accurately, leaves a smoother finish, and lasts up to twice as long as carbide-grit-coated teeth. Saws are for use on reinforced plastic, Kevlar, stone, brick, and other abrasive materials with high silicon content. Attach them to a drill or drill press. An arbor with pilot drill (sold separately) is required. To cut ceramic tile, you must use a 1/4" carbide-tipped pilot drill.