Fittings are threaded on both ends so you can connect them directly to a threaded hose or to pumps, cylinders, and other equipment in your hydraulic system.

Fittings have sharp barbs that grip push-on hose with no clamps or ferrules required. The more you pull on the fittings, the tighter the hose will grip. Use in low-pressure hydraulic applications up to 350 psi.

Crimp these fittings onto hydraulic hose for a permanent, leak-tight connection. Since they crimp on, they handle higher pressure than screw-on fittings.

Use these two-piece fittings in grease and lubrication lines. They screw directly onto hose without the need for a separate adapter. When assembled, the fitting compresses against the hose, forming a strong seal. Also known as reusable fittings, they can be unscrewed from the hose end and used on a new hose.

Cut the hose to your desired length and attach the fittings. You don't need any special equipment to install.

Heat chemicals to prevent them from freezing or becoming too thick. With a self-regulating heating wire, the liquid inside this hose stays warm and keeps flowing.

Although only half the weight, this hose resists wear and tear 240 times better than our standard rubber hydraulic hose. The fittings come attached, so this hose is ready to connect to a male threaded fitting on one end and a female one on the other.

The new standard for rubber hydraulic hose, this hose bends twice as sharply and resists wear and tear 80 times better than our basic hydraulic hose. It comes with female threaded fittings already attached, saving you time.

Internally reinforced with four steel wire spirals, this hose resists bursting from rapid changes in pressure and flow. To save you time, this hose comes with female threaded fittings already attached.

Individually bagged to prevent contamination, these fittings are suitable for applications that require a high level of cleanliness.

The threads on the tube end of these fittings are Class 3A or 3B and adhere to tighter tolerances than other 37° flared fittings.

Use these fittings at pressures up to 9,700 psi. Also known as instrumentation fittings, they are made to tight tolerances for use in high-precision applications. They are compatible with Swagelok®, Let-Lok, and Parker A-Lok fittings.

Use these sleeves with a nut and fitting to provide a tight metal-to-metal seal on steel tubing that is flared to 37°.

Also known as JIS (Japanese Industrial Standard) fittings.

The external hex bolt on these fittings allows for easy installation in cramped spaces. They are also known as banjo-style fittings and JIC (Joint Industrial Council) fittings. They provide a tight seal on tubing that is flared to 37°.