Turn the dial to control the percentage of time that these heaters cycle on, from 5% to 100%. Commonly used to thaw pipes, prevent valves from freezing, and heat beakers and flasks in labs, they're good for temporary and occasional use where rapid heating is required but precise temperature control is not.

With a cable that supplies the same wattage along the entire length, these heaters remain consistent regardless of the surrounding temperature. All require a temperature switch or controller to regulate heat output.

Rated for a maximum heat output of 900° F, these heaters are often used for thawing frozen pipes and rapid spot heating.

When the ambient temperature changes, these heaters automatically adjust the heat output along the length of their cable. Also known as self-regulating heat cable, they don’t require a separate temperature switch or controller.

Keep liquid in your pipes from freezing, maintain a specific viscosity, and prevent condensation in cold areas.

Stick these flexible heat sheets to container surfaces to warm contents without direct contact.

Also known as foil heaters, these bend around corners and edges without causing damage to the heating element.

FM approved, these heat sheets are safe for use in areas with infrequent exposure, such as from a spill or a ventilation system failure, to flammable gases, liquids, and dust.

Often used with extrusion, injection, and blow-molding machinery, these heaters clamp around nozzles to keep material warm for consistent discharge.

Thaw pipe without direct access to or knowing exactly where the frozen section is.

Often used to recirculate hot water in process baths and sinks, these lightweight heater/recirculators boost water temperature on the go.

Warm viscous food and beverages, such as syrup and honey, to keep it flowing even when the temperature drops.

The heating wire in this hose warms adhesives or paraffin wax to keep them flowing. Pair it with the matching temperature controller to set the temperature.