Cut the hose to your desired length and attach the fittings. You don't need any special equipment to install.

The heating wire in this hose warms adhesives or paraffin wax to keep them flowing. Pair it with the matching temperature controller to set the temperature.

Although only half the weight, this hose resists wear and tear 240 times better than our standard rubber hydraulic hose. The fittings come attached, so this hose is ready to connect to a male threaded fitting on one end and a female one on the other.

The new standard for rubber hydraulic hose, this hose bends twice as sharply and resists wear and tear 80 times better than our basic hydraulic hose. It comes with female threaded fittings already attached, saving you time.

Internally reinforced with four steel wire spirals, this hose resists bursting from rapid changes in pressure and flow. To save you time, this hose comes with female threaded fittings already attached.

To maintain the temperature of liquids as cold as -325° F, this hose has vacuum insulation and a reflective barrier. This prevents heat transfer in the same way a thermos does, so the exterior of the hose won’t freeze or form condensation. Thread the fittings on this hose onto a freezer or other equipment in your plant or laboratory.

Each hose is a different color so you can differentiate your lines.

Fittings are metal for better durability than plastic barbed hose fittings. They have sharper barbs than standard barbed hose fittings to grip push-on hose without the need for clamps or ferrules. The more you pull on the fittings, the tighter the hose will grip.

Also known as live swivels, these fittings swivel continuously 360° before and after installation. This not only makes installation easier, but also eliminates the twisting and kinking that can cause hose failure. Fittings are threaded on both ends so you can connect them directly to a threaded hose or to pumps, cylinders, and other equipment in your hydraulic system.

Fittings have sharp barbs that grip push-on hose with no clamps or ferrules required. The more you pull on the fittings, the tighter the hose will grip. Use in low-pressure hydraulic applications up to 350 psi.

Create or repair D.O.T. hose assemblies in the field with just a wrench and a vise, no crimper required.

No need for expensive crimping tools—these fittings make air conditioning and refrigeration assemblies with clamps.