Because this film dissipates heat, it is often used for printed circuit boards and power supplies.

This film is made with virgin Teflon® PTFE resins. It can handle extreme temperatures and resists most solvents.

Often used for circuit-breaker housings, manifolds, and semiconductor components, Ultem PEI offers excellent electrical-insulating properties.

Stronger than PTFE, PVDF offers good chemical resistance. Comparable to Kynar and Solef, it’s widely used for pump parts, tank liners, and seals.

In addition to a low-friction surface that prevents sticking and binding, this tough material is impact and wear resistant to handle the scuffs, scrapes, and strikes that other plastics can’t.

Practically nonabsorbent, HDPE won't swell when exposed to moisture. It is denser and more rigid than LDPE, plus it's more chemical resistant.

This film is often used as a separator when heating parts in an oven.

Because ABS maintains its toughness even after thermoforming, it’s often made into storage cases, tote trays, equipment housings, and protective gear.

At only half the weight of glass, polycarbonate maintains excellent impact resistance across a wide temperature range. It's comparable to Lexan, Hyzod, Tuffak, and Makrolon.

Polyester absorbs almost no moisture and resists swelling in wet environments. It is also known as PET and PETE.

The slippery surface on this FEP film prevents sticking. Use it as a release film when making molded parts.