Half as thick as regular hex nuts, these metric nuts fit into spaces with low height clearances. They’re a good choice for fastening most machinery and equipment. Also known as jam nuts, they can be threaded together to form a locknut that won’t move or loosen due to vibration. When fastening threaded rod, you can use two nuts to create a point for tightening the rod with a wrench. These nuts have less tensile strength than a standard hex nut when used alone. Made of steel, they’re best for dry environments, since moisture and chemicals will cause them to rust.

Zinc- and zinc yellow-chromate plated steel nuts resist corrosion in wet environments.

ISO 4035 (formerly DIN 439B) nuts are chamfered, so their edges are less sharp than DIN 936 nuts. This new ISO standard is functionally the same as the DIN standard it replaced, with slightly different tolerances for width.

For technical drawings and 3-D models, click on a part number.

Made from 18-8 stainless steel, these thumb nuts have good chemical resistance and may be mildly magnetic. The flange distributes the load over a large area and reduces stress where the nut meets the material surface. A knurled head provides a slip-resistant grip for controlled adjustment.

For technical drawings and 3-D models, click on a part number.

Made from zinc-plated brass, these thumb nuts are corrosion resistant in wet environments, electrically conductive, and nonmagnetic. The flange distributes the load over a large area and reduces stress where the nut meets the material surface. A knurled head provides a slip-resistant grip for controlled adjustment.

For technical drawings and 3-D models, click on a part number.