Bring your LED light back to life without the cost and hassle of replacing the entire fixture. These drivers replace your light’s failed driver and convert your building’s AC voltage into the low-voltage DC power your LEDs need. They also shield your lights from damaging voltage and current fluctuations.

To select the right driver, match its output wattage to the label on your existing driver. If there’s no exact match, round up to the nearest wattage.

Constant current drivers are the most common and are often used with commercial and industrial lighting. They’re best for consistent brightness. Those with multiple output currents include a switch, so you can select the output current closest to your needs. Keep them on hand to replace drivers with varying current requirements.

Constant voltage drivers are best for long runs of lights, such as strip or tape lights, to maintain stable voltage. Rated IP65, they’re protected from dust and low-pressure jets of water. They’re safe for use as replacements in outdoor fixtures exposed to rain and wet conditions.

Drivers with constant current or constant voltage perform one function at a time. They automatically detect the light’s requirements and supply the appropriate type of power.

Set the output current and dimming level on programmable LED drivers. Choose a programmer that matches the manufacturer series of your new driver.

Advance programmers connect to your PC. Key in the settings from the old driver’s label. Then tap the new driver to the programmer to transfer the settings wirelessly.

FieldSET programmers are handheld and don’t require a PC, making them ideal for frequent replacements. They’re rugged and can survive drops from up to 10 ft. These programmers automatically copy settings from FieldSET and Optotronic drivers—just connect the programming cord to the old driver. Then connect your new FieldSET driver to transfer the settings. These programmers cannot be used to program new Optotronic drivers. If your old driver is from another brand, you’ll need to manually enter the settings from the label.