Upgrade your fluorescent recessed lighting to energy-efficient LEDs without removing fixtures and exposing insulation. No need for a permit—these lights don't require opening the space above the ceiling. They connect to standard housings with the included springs and cables. Just remove the old lens, bulbs, drivers, and their wiring before installation. DLC (DesignLight Consortium) listed, these lights have been tested to confirm their energy efficiency. They’re also ETL listed for use in damp locations.

Adjust the light appearance and brightness to match your existing lighting. The frosted lens disperses light evenly to prevent glare on equipment.

Link these lights together to create different shapes with a sleek look. Also known as slot lights, they’re often found hung from, mounted to, or recessed into ceilings in offices and cafeterias. Any shape you form will be lit up continuously because the L, tee, and X connectors (sold separately) light up. Straight connectors (sold separately) link two lights together from the inside. There’s no need for tools for any connections. Remove the end panels, push together the electrical cables, and snap the light in place. You can link up to 32 feet of lights together with a single power connection. These lights include all necessary hardware for mounting.

Choose between a warm or neutral light appearance on the power supply to match existing lights. Each LED is inspected to make sure there are no visible differences in temperature and brightness, so you can combine multiple lights within the same space.

Illuminate steps to reduce the risk of tripping or falling, especially at night or in poorly lit areas. They mount flush with your wall or step, so they won’t get snagged or bumped. A glass lens protects the LEDs from dust and damage. UL listed for wet locations, these lights are sealed to keep out humidity as well as dripping and splashed liquids.

Mount these lights in a standard 1-gang outlet box (not included) with the included mounting bracket.

Install wall-mount lights alongside the step. Install step-mount lights on the riser of the step.

Mount these lights in recessed spaces so the lens is flush with the ceiling or wall. NEC Classes I and II, they’re safe to use in paint spray booths, blast booths, and other areas with ignitable concentrations of flammable or combustible gases, vapors, liquids, and dust.

LED lights have a cool light appearance that highlights white and blue tones for high visibility. They are lighter and easier to install than fluorescent lights, and you never have to change a light bulb. They’re UL rated for wet locations, so they’re sealed against humidity and dripping, splashing, and falling liquids.

Also known as troffers, these lights fit flush into most drop-ceiling grids. They’re fully sealed with an airtight gasket, so they’re rated IP65 for protection against low-pressure washdowns, humidity, and dust. Install them anywhere that requires frequent cleaning, even an ISO Class 5 clean room. They also meet NSF/ANSI 2, so you can use them in food processing areas with splashing liquid. These lights won’t shatter and contaminate your area—they’re rated IK10, the highest rating for impact protection. And since they’re IC rated, you won’t risk a fire if you install them in direct contact with insulation.

Casting a neutral light dispersed by a frosted lens, these lights won’t cause glare on equipment. The lens is made of acrylic to resist scratching and yellowing.

Mount these lights flush with ceilings in wet locations—all are sealed to keep out humidity and dripping, splashing, and falling liquids. Unlike recessed can lights, which require a separate housing, these fit directly into a cutout in your ceiling and are held in place by springs. With built-in LEDs, these lights last longer, are more efficient, and generate less heat than other light technologies. Use the switch on the power supply to choose between warm, cool, or neutral light—no more mismatched lights. All have passed strict U.S. and Canadian safety standards.