Brighten high-traffic areas with our most rugged ceiling lights. Rated IK10, the highest impact resistance rating, they’re protected by a 16-gauge cold-rolled steel frame and polycarbonate lens. A good choice for public spaces such as parking garages and stairwells, the lens is secured with tamper-resistant Torx screws to prevent vandalism. They have a center pin that makes them difficult to remove without special tools. The lens disperses light from the sides and bottom for ambient lighting.

Install these lights in covered areas indoors or outdoors—UL listed for wet locations, they’re sealed against humidity and dripping, splashing, and falling liquids.

Also known as jelly jar lights. These fixtures have a heat-resistant lens and a guard that protects the lens from breaking. They are CSA certified for hazardous locations where flammable/combustible gases, vapors, and liquids may be present. They are rated NEMA 4X for protection against corrosion and washdowns. Lights are sealed to keep moisture out. They can be hardwired to operate on any of the voltages listed. Some work with LED or incandescent bulbs (sold separately).

Styles 4 and 7 can be used in environments where ignitable concentrations of hazardous material are present under normal operating conditions, and/or during frequent equipment maintenance or failure. Rated for Class I, Divisions 1 and 2, Groups C and D; Class II, Divisions 1 and 2, Groups E, F, and G; and Class III, Divisions 1 and 2, these lights withstand ethylene, propane, conductive or metal dusts, carbonaceous dusts, nonconductive dusts, and combustible/ignitable fibers or flyings.

Also known as wall packs, these lights mount to exterior walls to illuminate building perimeters, entryways, loading docks, and other outdoor areas. No need for timers—a sensor automatically turns the light on at dusk and off at dawn. With built-in LEDs, these lights last longer, are more efficient, and generate less heat than other technologies. They produce a neutral white light appearance. The lens is prismatic to disperse light evenly, and made of durable, impact-resistant polycarbonate.

Also known as wall packs, these lights mount to exterior walls and ceilings. With built-in LEDs, they last longer, are more efficient, and generate less heat than other technologies. They can be hardwired to operate on any of the voltages listed. All have a prismatic lens that disperses light evenly.

Lights with a cool light appearance highlight white/blue tones creating good visibility at night.

Style A and D lights can be set to cool, neutral, or warm color appearances.

Ceiling-mount lights are also known as canopy lights.

Lights with a polycarbonate lens are more impact resistant than lights with a glass lens.

Lights with a photocell switch on/off automatically when they detect the presence or absence of light.

These lights are UL listed for Class I, Division 2, Groups A, B, C, and D for use in environments where ignitable concentrations of hazardous material occur infrequently, such as in the case of an accidental spill or failure of a ventilation system. They withstand acetylene, hydrogen, ethylene, and propane. Lights can be hardwired to operate on any of the voltages listed. They have a low-voltage disconnect so they won’t drain the backup battery. Use the test switch to check that the heads and battery are working properly. Heads adjust to any angle to direct light where needed. They cannot be sold to the listed areas due to energy efficiency requirements.

When the power goes out, these lights go on. These backup lights have built-in LEDs so they last longer, are more efficient, and generate less heat than other technologies. Rated for use in damp locations, these lights withstand exposure to humidity and moisture. Lights can be hardwired to operate on any of the voltages listed. They have a low-voltage disconnect so they won’t drain the backup battery. Use the test switch to check that the heads and battery are working properly. Heads adjust to any angle to direct light where needed.

Lights with a plastic housing resist corrosion better than lights with a steel housing.