Control multiple lights in the same footprint a standard light switch fits in.

Similar to a seesaw, these switches have an actuator that pivots when pressed to turn them on or off.

Also known as three-way switches, these are often used in large, open workspaces and can be wired on opposite ends of the room to control lights on the same circuit.

Combine a switch and receptacle into a single outlet box for a small footprint.

Install these switches inline on a lamp cord.

Customize motion-sensing light controls from your smartphone or tablet.

Fine-tune motion-sensing light controls from your smartphone or tablet. Mounting on the ceiling gives these light controls a clearer view of the room than wall-mount sensors, so they switch reliably.

Detect motion near your light fixture to turn lights on and off. Compared to switch-mount motion controls that detect from a single wall, these controls have a better view of the entire space since they sense motion from above.

Automatically turn outdoor lights on and off based on lighting conditions to conserve energy.

Never worry about turning lights on and off again. These controls turn lights on when people enter the room and off when rooms are empty or are bright enough.

Use these switches where ignitable gas and dust may be present. Their contact blocks are UL listed for Class I, Division 2, Groups B, C, and D hazardous locations.

Immediately cut power by pulling the cable.

Control two devices and delay the shut off of one device by up to one hour. These switches are often used with lights and fans for ventilation.

Switches fit single device (1 gang) outlet boxes.

Use your smart phone to turn equipment on and off at a set time and day.

Control equipment with high currents, such as landscape lighting, pumps, and heaters.

Detect the presence or absence of an object moving at high speeds with a light beam. These switches have a longer sensing distance than proximity and ultrasonic switches.

Detect objects as thin as a freshly sharpened pencil tip. These switches are best for tight spaces because they have a smaller light beam and can detect smaller objects than standard photoelectric switches.

Rated IP69K, these switches can withstand high-pressure, high-temperature washdowns and temporary submersion.

A slim design and a light beam that’s angled upwards allow these switches to sense objects from between conveyor rollers.

Monitor a wide area around dangerous machinery. If a person or object gets too close, these scanners signal your relay or controller to either trigger a warning or shut down the machinery.

The convenient, modern alternative to mechanical safety switches. These RFID switches are easier to install, fit a wider range of access points, and can mount horizontally.

Block access to machinery while it's running. These safety switches link to a single actuator, so no other RFID tag or card can interfere.

Prevent accidental bumps or vibration from triggering these safety switches unnecessarily—a strong magnet maintains the RFID signal between the actuator and switch until it's intentionally opened.

The IP66 rated housing not only shields these switches from washdowns but also makes them durable enough to be mounted outside of an electrical panel.

Install these switches inside an enclosure to prevent it from opening when power is on—turn the switch to disconnect power and release the door.

Rated IP69K, these switches are protected from high-pressure and high-temperature washdowns.

Prevent motors and other equipment from overheating or failing from not having enough voltage. When the supply voltage falls below 35% of the rated voltage, these switches will automatically turn off to protect the circuit from undervoltage.