Often used in large, open workspaces, these switches can be wired on opposite ends of the room to control lights on the same circuit. They're also known as three-way and four-way switches.

No need for separate outlet boxes—these combine a switch and a receptacle into a single box.

Switch lights on and off no matter the forecast.

Control multiple lights in the same footprint a standard light switch fits in.

Install these switches inline on a lamp cord.

Also known as three-way switches, these are often used in large, open workspaces and can be wired on opposite ends of the room to control lights on the same circuit.

Flat and completely smooth, these switches are easy to wipe down. With just a light tap, you can switch lights on and off, even if you’re wearing gloves.

Fine-tune motion-sensing light controls from your smartphone or tablet. Mounting on the ceiling gives these light controls a clearer view of the room than wall-mount sensors, so they switch reliably.

Prevent accidental actuation from bumps or vibration—these switches require you to grip and twist the lever to turn the switch. The contact block and actuator are all one piece, so they won’t separate in high-vibration applications.

A base that lights up draws attention to emergency stops. When pushed, these switches immediately cut power.

Immediately cut power with a single push.

Immediately cut power with a single push.

A red light flashes when the actuator is pushed, making it easy to see from a distance. They're rated IP65 for protection from washdowns.

Immediately cut power by pulling the cable.

Delay access to hazardous areas until conditions are safe; use these switches with machines that take time to stop after they are turned off. They mount to a door frame.

Cut power and keep it isolated to prevent equipment from starting up during inspection and maintenance. These switches are housed in a protective enclosure that resists denting, chipping, and cracking.

Protected by a steel enclosure, these switches withstand tougher conditions than switches in a plastic housing. Also known as safety switches, they have quick-make/quick-break action to eliminate arcing and prolong switch life.

Small yet mighty, these switches are about as tall and wide as an index card yet durable enough to mount directly to a wall.

Often used in electrical enclosures, these switches mount directly to DIN rails. They cut power and keep it isolated to stop equipment from starting up during inspection and maintenance.

Rated IP69K, these switches are protected from high-pressure and high-temperature washdowns.