When a moving object contacts the actuator on these switches, they open or close a circuit. They have the rapid-closing action of a snap-acting switch, but with a larger actuator for large objects.

Combine an actuator and a switch to assemble the exact limit switch you need.

Stack these slim switches together, or fit them into tight spaces. They're rated IP67 for protection from temporary submersion.

Secure these switches into panel cutouts using mounting nuts. They have a slim body so they can also be stacked together or fit into tight spaces.

Shorter and thinner than other safety limit switches, these are sized to fit tight spaces.

Rated IP67, these switches have an enclosure that shields their interior during temporary submersion. They open and close circuits in a snap—their quick actuation minimizes arcing and keeps contacts from sticking.

Also known as interlock switches, these ensure the safety of personnel by automatically shutting off power to machinery when an access door opens. They’re often used with machine guards.

Prevent accidental bumps or vibration from triggering these safety switches unnecessarily—a strong magnet maintains the RFID signal between the actuator and switch until it's intentionally opened.

These switches use DC input voltage and produce PNP or NPN signal output. They're often used with programmable logic controllers (PLCs).

The short body on these switches makes them suitable for tight spaces.

The flexible cable on these switches withstands applications that require frequent motion, such as robotics.

These inductive proximity switches sense metallic objects each time they pass through the slot, even when they’re obscured by water, oil, dirt, or a surface finish. Use them to measure the speed of rotating equipment and to count or detect moving objects, such as sheet metal being fed into a stamping process.

About half the length of our other flat-body proximity switches, these switches fit in crowded spaces and along rails.

Sense objects as they pass through the switch’s ring via tubing or a funnel. These switches are often used to monitor blockages, detect breaks in spooling wire, or count small metallic parts, such as screws, during the stamping process.

Twist the sensor to detect metallic objects where explosive dust or gas may be present—the sensor rotates for front, side, top, or bottom sensing. These switches are UL and C-UL listed as well as ATEX and IECEx certified for hazardous locations.

Mount these intrinsically safe switches to flat surfaces in volatile areas. Their low-current, low-voltage NAMUR signal means they won’t ignite or create sparks while in use. ATEX and IECEx certified, they meet international standards to protect against explosion where combustible dust and flammable gases are present.

These switches have a longer sensing distance compared to other proximity switches with the same diameter.

Mount these flat inductive switches to a base or rail to remotely detect metallic objects in wet and dirty environments.

These switches use a NAMUR signal to operate at a low current and voltage, so they won’t ignite or produce sparks. ATEX certified, they protect against explosion in environments containing flammable gases and combustible dust. Switches sense both metallic and nonmetallic objects.

These switches sense when a valve is open or closed, supporting flow and temperature control within your system and offering reliable feedback.