When a moving object contacts the actuator on these switches, they open or close a circuit. They have the rapid-closing action of a snap-acting switch, but with a larger actuator for large objects.

Start or stop equipment after a set number of rotations to avoid over-rotation.

Install these limit switches where changing a battery or routing wires might be difficult—they power themselves when a moving object contacts the actuator.

A sealed actuator prevents these switches from jamming, even when exposed to sand, mud, or dirt. With a slim design, you can stack them together or fit them in tight spaces.

Shorter and thinner than other safety limit switches, these are sized to fit tight spaces.

Rated NEMA 3S and IP69K, these switches can handle washdowns with high pressures and temperatures. They’re also protected from oil/coolant spraying, precipitation, and temporary submersion.

Rated NEMA 4 , these enclosed switches have a sealed actuator for protection from washdowns.

Also known as interlock switches, these ensure the safety of personnel by automatically shutting off power to machinery when an access door opens. They’re often used with machine guards.

Prevent accidental bumps or vibration from triggering these safety switches unnecessarily—a strong magnet maintains the RFID signal between the actuator and switch until it's intentionally opened.

Replace the hinges on access doors or machine guards with these switches to keep your team safe from active machinery.

These switches use DC input voltage and produce PNP or NPN signal output. They're often used with programmable logic controllers (PLCs).

These inductive proximity switches sense metallic objects each time they pass through the slot, even when they’re obscured by water, oil, dirt, or a surface finish. Use them to measure the speed of rotating equipment and to count or detect moving objects, such as sheet metal being fed into a stamping process.

Use these switches to sense metallic objects in environments containing flammable gases and combustible dust. ATEX and IECEx certified to protect against explosion, they produce a low-current, low-voltage NAMUR signal, so they won’t ignite or create sparks.

Turn the face on these switches to sense metallic objects from the front, sides, top, or bottom.

Sense objects as they pass through the switch’s ring via tubing or a funnel. These switches are often used to monitor blockages, detect breaks in spooling wire, or count small metallic parts, such as screws, during the stamping process.

Mount these intrinsically safe switches to flat surfaces in volatile areas. Their low-current, low-voltage NAMUR signal means they won’t ignite or create sparks while in use. ATEX and IECEx certified, they meet international standards to protect against explosion where combustible dust and flammable gases are present.

Often used with programmable logic controllers (PLCs), these switches use DC input voltage and produce PNP or NPN signal output.

Rated NEMA 4X, 6P, IP68 and IP69K, these switches resist corrosion and high-pressure, high-temperature washdowns, and can withstand temporary submersion.