Lighter than steel, these aluminum dock plates have two handles for quick manual positioning to bridge the gap between a truck and the dock. Use them when loading and unloading with hand trucks, pallet trucks, and other walk-on/walk-off equipment. Plates have a diamond surface texture to provide positive traction.

These plates allow forklift access so you can move them easily to bridge the gap between a truck and the dock. Use them when loading and unloading with forklifts, battery-operated hand trucks, and other powered equipment. Plates have a diamond surface texture for positive traction and lips on the sides lessen the chance of vehicle runoff.

Drive a fully loaded forklift into a truck, trailer, or dock door from ground level. When you’re done, these ramps break down to the size of a double-wide pallet for storage. They’re often referred to as yard ramps because they’re common in shipping yards. Made entirely of aluminum, these ramps stand up to the weather. The perforated surface gives your vehicle traction in all conditions and allows rain, snow, and dirt to pass through. These ramps have two included ratchet straps to secure them to a vehicle and prevent them from pulling away. Plates on either end facilitate smooth transitions from ground to ramp and ramp to truck.

No tools are needed for setup. Assembly can be completed in as little as 15 minutes with two people and a forklift.

Note: Check local, state, and federal codes, including OSHA, for safe set up and operating practices.

The tracks on these ramps retract after use for convenient carrying and storage. Originally designed for wheelchairs, they are useful in an industrial setting to roll equipment up a few stairs using a hand truck. Made of aluminum, these platforms are lightweight and easy to handle. They have an antislip surface and lips on the sides to lessen the chance of runoff.

Note: Check local, state, and federal codes, including OSHA, for safe set up and operating practices.

The heaviest dock plates we offer, these are built to endure high-traffic use. Forklift loops on the top flip up for easy maneuvering with a forklift and fold down when not in use. Use plates to bridge the gap between a truck and the dock when loading and unloading with forklifts, battery-operated hand trucks, and other powered equipment. They have a diamond surface texture for positive traction and lips on the sides lessen the chance of vehicle runoff.

Permanently attach these levelers to a dock to bridge the gap between the edge of the dock and a truck. Use them when loading and unloading with forklifts, pallet trucks, and hand trucks. Each leveler has a deck plate, a hinged lip plate, and two bumpers that are attached to bumper blocks. Dual extension springs act as a counterbalance to aid the leveler as it mechanically lifts the lip plate onto the truck bed; the springs return the lip plate to its original position when the truck pulls away. The plates have a diamond surface texture for positive traction.

To install, weld levelers to a dock face with a minimum 8" wide steel channel embedded into concrete at the dock edge. If the dock edge does not have an 8" wide steel channel, use the optional installation kit (sold separately) for bolt-on mounting.

Note: To determine load, take the gross weight of equipment, add typical load weight, and then multiply by two.

Use them to bridge the gap between a truck and the dock when loading and unloading with forklifts, battery-operated hand trucks, and other powered equipment. Plates have a diamond surface texture for positive traction and lips on the sides lessen the chance of vehicle runoff.