Locating Pads | McMaster-Carr

	System of Measurement System of Measurement

Inch

Metric

	Length Length

	Diameter Diameter

	Width Width

	Mount Type Mount Type


Press Fit	Threaded Stud

Screw

	Material Material

	Thread Size Thread Size

	Stud Diameter Stud Diameter

	For Mounting Screw Size For Mounting Screw Size

	Shape Shape

	Stud Length Stud Length

	Overall Width Overall Width

1 1/2"

	Overall Height Overall Height

	DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense Acquisition Regulations Supplement)

DFARS Specialty Metals
COTS-Exempt

	Number of Mounting Holes Number of Mounting Holes

	RoHS (Restriction of Hazardous Substances) RoHS (Restriction of Hazardous Substances)

RoHS Compliant

RoHS Compliant with
Exemptions

	REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration, Evaluation, Authorization and Restriction of Chemicals)

REACH Compliant

	Face Length Face Length

1 1/2"

	Thread Length Thread Length

	Height Height

	Mounting Hole Center-to-Center Mounting Hole Center-to-Center

	For Machine Table T-Slot Width For Machine Table T-Slot Width

	Edge Height Edge Height

299 Products

Locators, Supports, and Stops

Threaded Locating and Support Buttons

Use these buttons to support and position workpieces and fixtures from the bottom or side. Their hex shape lets you screw them into a threaded hole with a wrench or socket.

Press-Fit Locating and Support Buttons

Support and position workpieces and fixtures from the bottom or side. These buttons press into a drilled hole for permanent installation.

Screw-Mount Locating and Support Buttons

Mount through the counterbored hole with a socket head cap screw to support and position workpieces and fixtures from the bottom or side.

Domed-Head Locating and Support Buttons

Support rounded or irregularly shaped workpieces from the bottom or side with minimal contact.

Swiveling Locating and Support Buttons

The swiveling tip supports uneven and angled surfaces.

Locating and Support Pads

With a larger contact surface than locating and support buttons, these pads can support large workpieces and fixtures. They're also known as rest pads.

Fixture Keys

Sized to fit with precision in machine table T-slots, use these keys to locate fixtures and vises on your machine table.

Hole-Mount Fixture Keys

Install these keys in a drilled and reamed hole to locate fixtures and vises on your machine table. Also known as sine keys.

Locating Rails

For locating the side of a workpiece without milling a permanent slot into your fixture, screw these easily repositioned rails into threaded holes.

Spring-Loaded Guide Plungers

As the face of these plungers is pushed in, the internal spring applies outward pressure to hold a workpiece in position against stops and rails.

Spring-Loaded Guide Plungers for Thin Workpieces

Set the tang in a slot below the work surface to prevent thin material from sliding underneath the face.

High-Precision Index Plungers

To align two parts with more precision than standard spring plungers, these index plungers have a mating bushing that improves alignment and repeatability.

Adjustable Side Stops

Adjust the horizontal screw to hold workpieces of varying sizes in precise positions.

Spring-Loaded Work Supports

Slide these low-profile supports under a workpiece to provide support and reduce vibration.

Adjustable Support Screws

When working with large or flexible workpieces that could bow under machining pressure, use these screws as easy-to-install support points. Also known as jack screws or jig screws.

Ball-Lock Quick-Change Fixture Clamps

Build these components into fixture plates, machine subplates, and tombstones for quick changes. The system clamps and locates at the same time for accurate positioning with repeatability of ±0.0005".