We will reply to your message within an hour.
Twist these adapters onto female metric threads to change pitch or switch thread sizes.
Need to join two female-threaded parts, such as coupling nuts, with dissimilar inch thread sizes? Attach them to these adapters and tighten the exterior hex nut for a secure connection.
One side inch, one side metric, and a hex in the middle—these handy fasteners connect two female-threaded parts, such as coupling nuts, adapting from inch threads to metric. Tighten with a standard wrench.
Join two female-threaded parts of various thread types and sizes, while allowing air, liquids, wire, or other thin materials to pass through.
Change thread sizes or types, such as fine to coarse threads, on parts without changing gender.
In addition to joining male- and female-threaded parts, these adapters can increase or decrease metric thread sizes and change the thread pitch.
Change inch threads to metric with these adapters, or swap metric threads for inch. An external hex lets you tighten or loosen them with a wrench.
The through hole allows you to connect float rods to float valves.
Connect male- and female-threaded parts of different thread types and sizes, while allowing air, liquids, wire, or other thin materials to pass through.
Position components in assemblies, as well as separate or connect parts with these standoffs.
A nylon patch bonded to the threads adds friction, preventing these standoffs from loosening from vibration.
These standoffs are made to NAS specifications.
Mount components onto food processing lines, walls, and sanitary equipment while leaving space to clean in between.
The magnetic end of these standoffs makes it easy to temporarily mount or reposition components on magnetic surfaces.
Secure computer cables and panels.
Thread the male connection into a tapped hole and snap the other end into a panel for a secure hold that can be released for repairs and upgrades.
Turn these studs with a hex key for ease of installation.
These studs are also known as hanger bolts—use them to hang, mount, and fasten parts to wood structures.
Use these stud-style anchors with nuts.
Keep a variety of standoffs in different lengths and thread sizes on hand.
Fit these brackets through drilled holes in panels.
Use four brackets to support the top and bottom edges of panels without drilling holes in them.
No need to drill holes in panels—tighten the set screw to hold them in place.
Use these components in coordinate measuring machine (CMM) applications to raise a workpiece and reliably position it on a fixture plate with ¼"-20 holes.
Use adapters on the ends of forcing screws and face-grip puller legs when pulling shafts, bearing caps, and pinions.
Convert drum openings with metric or BSPP threads to a 2 NPT pipe size.