We will reply to your message within an hour.
Position components in assemblies, as well as separate or connect parts with these standoffs.
A nylon patch bonded to the threads adds friction, preventing these standoffs from loosening from vibration.
These standoffs are made to NAS specifications.
Mount components onto food processing lines, walls, and sanitary equipment while leaving space to clean in between.
The magnetic end of these standoffs makes it easy to temporarily mount or reposition components on magnetic surfaces.
Thread the male connection into a tapped hole and snap the other end into a panel for a secure hold that can be released for repairs and upgrades.
Twist these adapters onto female metric threads to change pitch or switch thread sizes.
Need to join two female-threaded parts, such as coupling nuts, with dissimilar inch thread sizes? Attach them to these adapters and tighten the exterior hex nut for a secure connection.
Join two female-threaded parts of various thread types and sizes, while allowing air, liquids, wire, or other thin materials to pass through.
One side inch, one side metric, and a hex in the middle—these handy fasteners connect two female-threaded parts, such as coupling nuts, adapting from inch threads to metric. Tighten with a standard wrench.
Change thread sizes or types, such as fine to coarse threads, on parts without changing gender.
Change inch threads to metric with these adapters, or swap metric threads for inch. An external hex lets you tighten or loosen them with a wrench.
Connect male- and female-threaded parts of different thread types and sizes, while allowing air, liquids, wire, or other thin materials to pass through.
In addition to joining male- and female-threaded parts, these adapters can increase or decrease metric thread sizes and change the thread pitch.
The through hole allows you to connect float rods to float valves.
Keep a variety of standoffs in different lengths and thread sizes on hand.
Use adapters on the ends of forcing screws and face-grip puller legs when pulling shafts, bearing caps, and pinions.
Use these components in coordinate measuring machine (CMM) applications to raise a workpiece and reliably position it on a fixture plate with ¼"-20 holes.
Convert drum openings with metric or BSPP threads to a 2 NPT pipe size.