Protect toggle switches from moisture and dust by replacing panel mounting nuts with these rubber covers.

Install these covers without removing switches from the panel—covers fit over mounting hardware.

Seal the panel cutout around a toggle switch.

Choose an actuator and contact block to make your own 22 mm plastic switch.

Made of stainless steel, these covers protect push-button actuators from impact.

An alarm sounds when the cover is lifted.

Wrap these lockouts around levers on battery disconnect switches and other disconnect switches.

Lock out hoist controls, large electrical connectors, spouts, and other odd-sized controls.

Mount near machines your team is repairing to lock them out with fewer padlocks.

Lock out electrical panels, switches, and other power sources to keep machinery off during repairs.

A Danger label on these hasps alerts passersby that an energy control is locked out. Use them to make sure machinery doesn’t get powered up during repairs.

Like two lockout hasps in one, there's a jaw at each end with different clearances for added versatility.

With a fold-over clasp design, these hasps shut tight enough that picks and other tools can't pry them open.

With a smaller overall length, these lockout hasps fit in tighter spaces than other lockout hasps yet still hold a similar number of locks.

A fold-over closing design hinders prying, while a slot instead of holes makes it easy to install multiple padlocks.

Lock out circuit breaker switches with a through-hole to prevent accidental start-ups. These lockouts have pins that fit in the hole for a more secure hold than clamp-on lockouts.

From a single point, lock out multiple breaker switches—these lockouts wrap around an entire tie bar so it won’t budge. Compared to clamp-on lockouts, they’re more secure.

Lock out multiple breaker switches from a single point—these lockouts wrap around an entire tie bar on your DIN-rail-mount circuit breaker so it won’t budge. Compared to pin-in and pin-out lockouts, they’re more secure.

With pins that stick into the holes inside your switch housing, these lockouts are more secure than clamp-on lockouts. They’ll secure tie bars, too—attach them to just one of the switches to lock out the whole thing.

Secure a single breaker switch with multiple padlocks to keep electricity safely off until the entire team is finished with a maintenance task.