A housing seals in anything that could ignite flammable material, so you can use these switches where explosive gas, dust, and fibers may be. They actuate with a quick push.

Use these switches where ignitable gas and dust may be present. Their contact blocks are UL listed for Class I, Division 2, Groups B, C, and D hazardous locations.

A red light flashes when the actuator is pushed, making it easy to see from a distance. They're rated IP65 for protection from washdowns.

Prevent accidental actuation from bumps or jostles—these switches require you grip and twist a lever to turn them on or off. Install them in 30 mm dia. cutouts.

Use these switches where ignitable gas, dust, and fibers may be present. They're UL and C-UL listed for hazardous locations.

Snap these switches onto your DIN rail to mount them. With a toggle switch and receptacle combined, you can actuate power and plug in devices from a single box.

These switches are rated for environments where hazardous material is present.

Rated NEMA 6P and IP68, these switches are protected against washdowns, corrosion, and temporary submersion.

Control equipment from up to 40 feet away—these switches include a transmitter and a receiver that connects to equipment.

Make or break an electrical circuit. These contact blocks mount to manual switches and transmit an electrical signal when the switch actuator is engaged.

With a slim shape, these switches fit comfortably in your hand.

Never worry about your pendant switch losing power. These pendant switches generate enough power from pushing the button to send a signal to a receiver up to 330 feet away.

Sized for 22 mm dia. panel cutouts, these switches require a key to turn circuits on or off, limiting access to sensitive equipment.

Connect these switches to a cable to control circuits from a distance. They're typically used to turn off production lines and material handling systems.

Immediately cut power by pulling the cable.

It takes two hands to activate these switches, minimizing the risk of accidental equipment start up.

Install these switches inline on a lamp cord.

Also known as three-way switches, these are often used in large, open workspaces and can be wired on opposite ends of the room to control lights on the same circuit.

Similar to a seesaw, these switches have an actuator that pivots when pressed to turn them on or off.

Control lights by transmitting a wireless signal from these switches to a control relay on your fixture.

Flat and completely smooth, these switches are easy to wipe down. With just a light tap, you can switch lights on and off, even if you’re wearing gloves.

No need for separate outlet boxes—these combine a switch and a receptacle into a single box.

Designed to mount on an electrical enclosure, these switches control motors, lighting, and electric heat circuits.

Safely turn motors on and off near ignitable gases and dust—the housing on these switches seals in anything that could ignite flammable material.

Housed in a durable steel enclosure.

Prevent changes in frequency from damaging sensitive equipment.

Built into an enclosure, these temperature controllers are protected when sitting on your workbench. They turn heating equipment on and off using a proportional-integral-derivative (PID) control algorithm to make fine adjustments, giving you the most precise and stable temperature control.

Install these valves in HVAC and refrigeration systems to control CO2. For a permanent, leak-tight connection, solder them to metal tubing.

Attach a gauge to the side port on these valves to monitor pressure, temperature, and other measurements in your line. Use with water and air.