Choosing an Electrical Switch
More
Contact Blocks for Manual Switches
Make or break an electrical circuit. These contact blocks mount to manual switches and transmit an electrical signal when the switch actuator is engaged. You can stack multiple blocks, so a single switch can control several circuits. This is helpful in setups that require multiple systems to turn on or off at the same time. For example, the switch on a conveyor line could turn off the conveyor and turn on a diverter and alarm.
For technical drawings and 3-D models, click on a part number.
| No. of Circuits Controlled | Switch Starting Position | No. of Terminals | Industry Designation | Wire Connection Type | For Switch Manufacturer Series | Each | |
Schneider Electric—Hermetically Sealed | |||||||
|---|---|---|---|---|---|---|---|
| 1 | 1 Off (Normally Open) | 2 | SPST-NO | Screw Terminals | 9001K | 000000000 | 0000000 |
| 1 | 1 On (Normally Closed) | 2 | SPST-NC | Screw Terminals | 9001K | 000000000 | 000000 |
Joystick Switches
Intuitively steer and position cranes, robot arms, and other machinery that moves in multiple directions—your equipment will follow the movements you make with these joysticks. They control multiple circuits as you move them in different directions and patterns. Assemble a complete switch with an actuator and at least one contact block (sold separately). All actuators include a mounting clip that can fit up to two contact blocks. They’re NEMA and IP rated for protection from dust, washdowns, and oil/coolant spraying.
Two-position actuators require one to four contact blocks. Four-position actuators require two to four contact blocks. They are off in the center position.
Momentary actuators can only be locked in the off position. Maintained actuators can be locked in any position.
Chrome-plated steel actuators resist wear better than rubber actuators.
For technical drawings and 3-D models, click on a part number.
| Direction of Operation | Switch Action | Actuator Material | Dp. Behind Panel | Environmental Rating | Manufacturer | Each | |
2 Position for 30 mm Panel Cutout Dia. | |||||||
|---|---|---|---|---|---|---|---|
| Up, Down | Springs Back (Momentary) | Chrome-Plated Steel | 1 7/16" | IP66, NEMA 13, NEMA 6 | Schneider Electric | 000000000 | 0000000 |
| Up, Down | Stays Switched (Maintained) | Chrome-Plated Steel | 1 7/16" | IP66, NEMA 13, NEMA 6 | Schneider Electric | 000000000 | 000000 |
4 Position for 30 mm Panel Cutout Dia. | |||||||
| Up, Down, Left, Right | Springs Back (Momentary) | Chrome-Plated Steel | 1 7/16" | IP66, NEMA 13, NEMA 6 | Schneider Electric | 000000000 | 000000 |