Simple to use, these switches actuate with a quick push.

A housing seals in anything that could ignite flammable material, so you can use these switches where explosive gas, dust, and fibers may be. They actuate with a quick push.

The built-in contact block in these switches extends behind the panel half the depth of most other 22 mm switches, saving valuable space.

A base that lights up draws attention to emergency stops. When pushed, these switches immediately cut power.

Save space on your panel by using one switch for several tasks. These switches actuate with the push of a button.

Actuate these switches with a quick push. A housing seals in anything that could ignite flammable material, so you can use them where ignitable gas and dust may be present.

Push the button to actuate these switches. Colored actuators help you tell switches apart without reading labels.

Immediately cut power with a single push.

Rated NEC Classes I, II, and III, these switches have a housing that keeps fire and sparks in, so they won’t ignite gases, vapors, or dust. To save space on your panel, they can control multiple circuits.

Because these switches mount flush against a panel, they're easy to clean and hard to damage.

Install in 10 mm dia. cutouts.

Sized for 4 mm or 6 mm panel cutouts, these switches are often used with circuit boards to control electronics.

Install in 16 mm dia. cutouts.

Because these switches mount flush against a panel, they're easy to clean and hard to damage.

Actuate these switches with a quick push.

A rubber seal protects these switches from splashing water.

Maximize the space in a panel—these switches are half the size of most toggle switches.

Prevent accidental actuation—these toggle switches must be pulled up before they can switch a circuit.

Grip and twist a lever to turn these switches on or off—they’re designed to prevent accidental actuation. Install them into standard-sized panel cutouts.

Thanks to their ability to handle higher current than switches with contact blocks, these switches are often found in applications from large motors to warehouse lighting systems.

Prevent accidental actuation from bumps or jostles—these switches require you grip and twist a lever to turn them on or off. Install them in 30 mm dia. cutouts.

Avoid accidental actuation—these switches won’t turn on or off until you grip and twist the lever. Install in a 16 mm dia. cutout.

Choose from a variety of messages and colored lenses to combine a rocker with a base and wiring socket for a complete switch.

Rated IP67 for protection from dust and temporary submersion.

Also known as high-inrush current switches, these switches can handle starting currents up to 10 times greater than their rating, such as when a motor starts.

Choose an actuator and contact block to make your own 30 mm switch.

Choose an actuator and contact block to make your own 22 mm plastic switch.

To prevent accidental actuation and limit access to sensitive equipment, these switches require a key to turn circuits on or off. The contact block and actuator are all one piece, so they won’t separate in high-vibration applications.

Install these key switches in 3/4" dia. panel cutouts. They require a key to turn circuits on or off, limiting access to sensitive equipment.

Install these key switches in 30 mm dia. panel cutouts. They require a key to turn circuits on or off, limiting access to sensitive equipment.

These 16 mm switches require a key to turn circuits on or off, limiting access to sensitive equipment.

An infrared light beam senses the lightest finger contact to switch a circuit on or off.

The light touch of a finger turns circuits on and off without pressing down a contact. Program these switches to fit your application—control their color, pattern, and sensitivity.

Turn these switches by hand.

Unlike breakers that trip thermally, these breakers have a hydraulic-magnetic trip mechanism, so they aren’t affected by changes in temperature.

Built to resist vibration and corrosion in harsh environments, these circuit breakers protect against overload and short circuits in low-voltage automotive and other electronic applications.