Install in 12 mm dia. cutouts.

A housing seals in anything that could ignite flammable material, so you can use these switches where explosive gas, dust, and fibers may be. They actuate with a quick push.

The built-in contact block in these switches extends behind the panel half the depth of most other 22 mm switches, saving valuable space.

Push the button to actuate these switches. Colored actuators help you tell switches apart without reading labels.

Actuate these switches with the push of a button. Their buttons are distinct colors to help you quickly spot switches without labels.

Save space on a panel by using one switch to perform multiple switching functions.

Operate low-voltage devices that require less than 48 volts, such as doorbells and buzzers.

Sized for 4 mm or 6 mm panel cutouts, these switches are often used with circuit boards to control electronics.

Install in 14 mm dia. cutouts.

A protective plastic enclosure resists dents, chips, and cracks, so you can install these switches outside of panels.

Save space in your setup—these switches double as handles on machines and equipment.

Snap these switches onto your T-slotted framing rails—no need to drill or disassemble your existing structure.

These switches are protected from corrosion, high-temperature and high-pressure washdowns, and oil/coolant spraying. Install them in 22 mm dia. cutouts.

Prevent accidental actuation from bumps or vibration—these switches require you to grip and twist the lever to turn the switch. The contact block and actuator are all one piece, so they won’t separate in high-vibration applications.

Prevent accidental actuation from bumps or jostles—these switches require you grip and twist a lever to turn them on or off. Install them in 30 mm dia. cutouts.

Avoid accidental actuation—these switches won’t turn on or off until you grip and twist the lever. Install in a 16 mm dia. cutout.

A rubber seal protects these switches from splashing water.

Maximize space in a panel—these switches are smaller than most standard rocker switches.

Also known as high-inrush current switches, these switches can handle starting currents up to 10 times greater than their rating, such as when a motor starts.

The wide surface of these switches makes them easy to press on and off, even if your hands are full and you need to use an elbow.

Keep your hands free for other tasks by triggering switches with your foot.

Rated NEMA 6P and IP68, these switches are protected against washdowns, corrosion, and temporary submersion.

Choose an actuator and contact block to make your own 22 mm plastic switch.

Choose an actuator and contact block to make your own 22 mm metal switch.

Control machinery from a safe distance, or use these switches as call buttons.

With a slim shape, these switches fit comfortably in your hand.

Sized for 22 mm dia. panel cutouts, these switches require a key to turn circuits on or off, limiting access to sensitive equipment.

Install these key switches in 3/4" dia. panel cutouts. They require a key to turn circuits on or off, limiting access to sensitive equipment.

Install these key switches in 30 mm dia. panel cutouts. They require a key to turn circuits on or off, limiting access to sensitive equipment.

These 16 mm switches require a key to turn circuits on or off, limiting access to sensitive equipment.

Made with stainless steel conductors, these switches resist corrosion in damp areas. They’re less than 1/4” thick, so they’ll fit under floor mats and in other tight spaces.

These narrow switches are also thin enough to be hidden under carpeting or installed anywhere space is limited.

Step or press anywhere along the switch to control doors, lights, or alarms.

Thicker than standard safety switch mats, these withstand repeated impact from heavy and sharp objects.

Customize the length of these switches by cutting them from a 25-foot roll.

Install these switches inline on a lamp cord.

To protect equipment and personnel, these controllers shut down your machine when it gets too hot.