Install in 12 mm dia. cutouts.

A quick push is all it takes to actuate these switches.

The built-in contact block in these switches extends behind the panel half the depth of most other 22 mm switches, saving valuable space.

Sized for 4 mm or 6 mm panel cutouts, these switches are often used with circuit boards to control electronics.

More durable than standard metal switches, these can handle tough, repetitive use.

Actuate these switches with a quick push. A housing seals in anything that could ignite flammable material, so you can use them where ignitable gas and dust may be present.

Immediately cut power with a single push.

A protective plastic enclosure resists dents, chips, and cracks, so you can install these switches outside of panels.

These aluminum switches are rated NEMA 4, NEMA 13, and IP66 for protection from washdowns and oil/coolant spraying.

Mount these switches in an outlet box. Also known as palm-button switches, they have a large button that makes them easy to use even while wearing gloves.

The wide surface of these switches makes them easy to press on and off, even if your hands are full and you need to use an elbow.

Grip and twist a lever to turn these switches on or off—they’re designed to prevent accidental actuation. Install them into standard-sized panel cutouts.

Make or break an electrical circuit. These contact blocks mount to manual switches and transmit an electrical signal when the switch actuator is engaged.

Choose an actuator and contact block to make your own 22 mm metal switch.

Designed for use near ignitable gases, fibers, and dust, these switches have a housing that seals in anything that could ignite flammable material. They require a key to turn circuits on or off, preventing accidental activation and limiting access.