A quick push is all it takes to actuate these switches.

Because these switches mount flush against a panel, they're easy to clean and hard to damage.

Mount these switches in panel cutouts where changing a battery or routing wires might be difficult—they power themselves when you push the button.

A single-piece construction prevents the contact block from separating from the actuator in high-vibration applications.

A base that lights up draws attention to emergency stops. When pushed, these switches immediately cut power.

Actuate these switches with the push of a button. Their buttons are distinct colors to help you quickly spot switches without labels.

Actuate these switches with a quick push. A housing seals in anything that could ignite flammable material, so you can use them where ignitable gas and dust may be present.

Use these switches where ignitable gas and dust may be present. Their contact blocks are UL listed for Class I, Division 2, Groups B, C, and D hazardous locations.

Install in 16 mm dia. cutouts.

Because these switches mount flush against a panel, they're easy to clean and hard to damage.

Sized for 4 mm or 6 mm panel cutouts, these switches are often used with circuit boards to control electronics.

Install in 12 mm dia. cutouts.

Operate low-voltage devices that require less than 48 volts, such as doorbells and buzzers.

Install in 14 mm dia. cutouts.

Actuate these switches with a quick push.

These aluminum switches are rated NEMA 4, NEMA 13, and IP66 for protection from washdowns and oil/coolant spraying.

A protective plastic enclosure resists dents, chips, and cracks, so you can install these switches outside of panels.

Keep a switch within reach—but not in the way. These mount to the underside of desks, tables, and shelves to keep work surfaces clear and reduce the risk of accidental presses.

Use these switches where ignitable gas and dust may be present. They're rated for use in hazardous locations.

These familiar push-button switches mount to flat surfaces.

Immediately cut power with a single push.

Clip these switches onto nearby structures made from T-slotted framing to quickly cut power with the push of a button.

Instantly cut power when obstacles or distance make it hard to reach your machine in time.

Choose from a variety of messages and colored lenses to combine a rocker with a base and wiring socket for a complete switch.

Also known as high-inrush current switches, these switches can handle starting currents up to 10 times greater than their rating, such as when a motor starts.

Maximize space in a panel—these switches are smaller than most standard rocker switches.

These switches withstand temporary submersion.

Control machinery from a safe distance, or use these switches as call buttons.

Control machinery such as cranes, hoists, or trolleys with a wireless switch. About the size of a cell phone, these switches fit in the palm of your hand.

A durable rubber housing covers the buttons and protects these switches from impact.

Choose an actuator and contact block to make your own 22 mm plastic switch.

Choose an actuator and contact block to make your own 16 mm switch.

Tug on the cable anywhere along your line to immediately cut the flow of power. This multi-functional unit also sends a signal to restart machinery with the push of a button, doing the job of two units in one.

Combine a push-button actuator with a switching mechanism to build a complete switch.

Small enough to fit in tight spaces, these circuit breakers mount through panels and are UL 489-rated for branch circuit protection.

An electronic trip mechanism makes these circuit breakers fast, precise, and consistent. They continuously monitor current and trip at a precise value compared to the much wider current range in traditional thermal-magnetic breakers.

Replace any Edison-base fuse with these resettable circuit breakers.