Rounded jaws reduce damage to aluminum and other lightweight metal.

The jaws have V-notches in 1/4" increments to measure the depth of bends.

Turn your impact driver into a power crimper, and create raised edges on sheet metal more quickly than hand crimpers.

Create a raised edge in sheet metal that locks into the rolled edge of another piece.

Bend wire and rod up to 1/2" diameter and flat stock up to 1/4"×1" with these rugged steel benders.

Also known as ring rollers, these curvers shape wire, rods, and flat stock into curves and circles.

Reinforced construction lets these benders handle thicker material than bench-top benders.

Open sheet metal seams without cutting. The jaws slide under seams to pry the sheets apart.

Fold corners in flat metal sheets to create your own bin boxes, drip pans, and other three-dimensional objects. Similar to tucking the corners of a bedsheet, these benders twist and wrap the metal into triangle-shaped folds to form corners.

Create long, uniform folds on the edges of sheet metal.

Pull and pinch metal extrusions, such as L-channels, so they fit precisely around contoured edges and frames.

Make bends up to 135° in metal sheets. Benders have a clearance of 4" for insertion and removal of large workpieces such as vehicle panels and duct work.

Protect thin-wall tubing from crimping and collapsing while bending by hand.

Smoothly bend hard metal tubes, such as steel and titanium, without causing crimps or kinks.

Grip tubing from the side to make bends in tight spaces.

Bend more than one size of tubing without adjusting the bending head.

These tools include one slide bar and 10 bending mandrels for 1/4" to 5/8" tube OD.

Powerful enough to bend conduit and pipe to the angle you need, these are for use on Schedule 40 pipe.

Create smooth, accurate bends in round heat pipe for routing heat away from sensitive electronic components and toward a heat sink.

When you're working with exposed conduit, these benders make offset bends so your conduit matches knockout holes in electrical boxes.

Place on the back side of your workpiece to act as a support when you strike it. Also known as dolly blocks.

Use the domed end of the head for forming soft metal, rounding off edges, and closing rivets. The flat striking face is for driving nails, pins, punches, and chisels.

The face and head are made of aluminum-bronze that is Factory Mutual approved, so these tools inhibit sparking, resist corrosion, and are nonmagnetic. Use the domed end of the head for forming soft metal, rounding off edges, and closing rivets. The flat striking face is for driving nails, pins, punches, and chisels.

Set solid rivets by hand. These tools are also known as paneing, setting, and seaming hammers.

Flatten bumps, bends, and curves on coiled wire with these straighteners.

Choose these stainless steel pliers for environments where moisture and other contaminants are present. They resist corrosion that can hinder joint movement, but the jaws will wear more quickly than a steel tool. Also known as round-nose pliers, use them for looping and bending wire.

The soft jaws on these pliers bend and loop wire without scratching or marring it.

Deep serrations provide the firm grip necessary for pulling rebar tie wire, and the hook-shaped handle end keeps your hand from slipping off. Also known ironworkers’ pliers, these tools also bend and cut wire.