A screw presses the clamp onto the wire for a secure hold.

Covers—Snap onto the exposed side of a terminal block to prevent accidental contact with a live wire.

End Stops—Mount at the end of a group of terminal blocks so they don't slide when vibrated or bumped.

Bar Jumpers—Metal poles create an electrical connection between blocks, so you can connect multiple components with a single wire. Blocks must be the same width for the jumpers to fit. Cut jumpers to size with a hacksaw or high-force wire cutter. Add covers so jumpers don't touch the screws on the outermost blocks.

Noninsulated—Terminal blocks with noninsulated jumpers lose their IP20 rating for touch protection because the jumpers introduce exposed metal to the circuit.

Instead of fussing with screws, flip the lever to clamp your wire into the terminal.

Covers—Snap onto the exposed side of a terminal block to prevent accidental contact with a live wire.

End Stops—Mount at the end of a group of terminal blocks so they don't slide when vibrated or bumped.

Bar Jumpers—Metal poles create an electrical connection between blocks, so you can connect multiple components with a single wire. Blocks must be the same width for the jumpers to fit. Cut jumpers to size with a hacksaw or high-force wire cutter. Add covers so jumpers don't touch the screws on the outermost blocks.

Connect grounding wire to DIN rail so fault currents can safely flow to ground. These terminal blocks should only be used for grounding circuits.

A screw presses the clamp onto the wire for a secure hold.

Covers—Snap onto the exposed side of a terminal block to prevent accidental contact with a live wire.

End Stops—Mount at the end of a group of terminal blocks so they don't slide when vibrated or bumped.

Install a fuse in the built-in fuse holder so excess current doesn't damage your equipment. If the current exceeds the limit, the fuse will blow and cut power to connected components.

A screw presses the clamp onto the wire for a secure hold.

Covers—Snap onto the exposed side of a terminal block to prevent accidental contact with a live wire.

End Stops—Mount at the end of a group of terminal blocks so they don't slide when vibrated or bumped.