Make angled cuts in material that’s too wide for a standard miter saw—the arm on these saws slides for added reach. Swivel the head to make miter cuts across the width of your workpiece. For bevel cuts downward through your material, tilt the blade. While primarily used to cross-cut wood, these saws can also handle metal and other materials.

Use an abrasive wheel with these saws for general purpose cutting jobs. You can cut steel square structural tubing, aluminum conduit, and other hard materials.

Our smallest and lightest miter saw weighs only 12 pounds—great to use throughout your facility. These saws are good for light duty cutting through small pieces of wood, plastic, and metal. Part of the base swivels to make angled miter cuts. Use the included vise to secure your workpiece. Its V-groove holds round pieces like pipes, tubes, and rods.

For cooler, cleaner cuts, these saws use a metal blade instead of an abrasive wheel. They slice through metal at low speeds, which means less dust, fewer sparks, and burr-free edges. Often used to cut steel pipe or strut channel down to size, they deliver precise, perpendicular cuts. The vise secures and releases material quickly—unlike standard vises, its jaws open and close without multiple turns of the handle.

These lightweight saws have a smaller wheel diameter than standard bench-top chop saws. They’re small and easy to move, yet powerful enough to cut through steel. They use metal blades instead of abrasive wheels for cooler, burr-free cuts with few sparks, fumes, and dust. Operate these saws at a low rpm to make quick, straight cuts in metal. A quick-release vise lets you secure and release your material quickly with the flip of a lever. Connect a dust collector or vacuum to the dust-extraction port to keep your work area clean and improve air quality.

This saw is less than half the weight with a smaller wheel diameter than standard bench-top chop saws. Use abrasive wheels with this saw to power through hard materials.

Powered by a high-torque motor, these saws cut through thicker and harder materials than standard chop saws. They can also run continuously for longer, even when cutting hard materials like angle iron or tool steel. With a base made of either steel or cast iron, these saws are durable enough to hold up in foundries, metal fabrication plants, and other tough environments. Use with abrasive wheels (sold separately).

The motor in these saws puts out higher torque than standard floor chop saws, so they slice through angle iron, tool steel, and other thick, hard materials. They can also run continuously for longer than standard floor chop saws. With a strong base made from steel, these saws are designed to hold up in rugged environments like foundries and metal fabrication plants. They’re great for sawing through metal bars and pipes, cutting tool steel rods to length, and trimming down raw stock before milling it in a CNC machine. Use with abrasive wheels (not included). These saws must be hardwired.

Pins hold hose slightly bent, pulling it apart as the knife-edge blade slices a straight, smooth cut. These saws make cleaner cuts than chop saws in rubber hose; reinforced air, water, and coolant hose; and hydraulic hose. For smoke-free cuts, connect a wet/dry vacuum to the dust-hose port.