A quick push is all it takes to actuate these switches.

Because these switches mount flush against a panel, they're easy to clean and hard to damage.

Mount these switches in panel cutouts where changing a battery or routing wires might be difficult—they power themselves when you push the button.

A base that lights up draws attention to emergency stops. When pushed, these switches immediately cut power.

A single-piece construction prevents the contact block from separating from the actuator in high-vibration applications.

Change the cover on these switches without replacing them entirely—they come with seven snap-on covers in different colors. The colors help you quickly identify switches without labels.

Actuate these switches with the push of a button. Their buttons are distinct colors to help you quickly spot switches without labels.

Actuate these switches with a quick push. A housing seals in anything that could ignite flammable material, so you can use them where ignitable gas and dust may be present.

Save space on a panel by using one switch to perform multiple switching functions.

Use these switches where ignitable gas and dust may be present. Their contact blocks are UL listed for Class I, Division 2, Groups B, C, and D hazardous locations.

Operate low-voltage devices that require less than 48 volts, such as doorbells and buzzers.

Immediately cut power with a single push.

Send a signal from your circuit board with the push of a button.

Install in 12 mm dia. cutouts.

Operate low-voltage devices that require less than 48 volts, such as doorbells and buzzers.

Actuate these switches with a quick push.

With a stainless steel enclosure, these switches are more durable than aluminum and plastic. They're rated NEMA 4X for protection from corrosion and washdowns.

Keep a switch within reach—but not in the way. These mount to the underside of desks, tables, and shelves to keep work surfaces clear and reduce the risk of accidental presses.

Made of yellow polycarbonate plastic, these enclosed switches are easy to see and resist dents, chips, and cracks. They are more corrosion resistant than aluminum enclosed switches and withstand washdowns and oil/coolant spraying.

These aluminum switches are rated NEMA 4, NEMA 13, and IP66 for protection from washdowns and oil/coolant spraying.

These familiar push-button switches mount to flat surfaces.

Mount these switches in an outlet box. Also known as palm-button switches, they have a large button that makes them easy to use even while wearing gloves.

Clip these switches onto nearby structures made from T-slotted framing to quickly cut power with the push of a button.

These switches withstand temporary submersion.

A durable rubber housing covers the buttons and protects these switches from impact.

Also known as deadman switches, these switches make sure equipment only runs if you lightly press the hand grip. If you let go or a shock tightens your grip, they cut power.

Operate equipment from up to 330 feet away—these switches include a transmitter and a receiver that connects to equipment.

Control cranes and other mobile machinery in dirty, outdoor, and wet environments without damaging your switch.

Choose an actuator and contact block to make your own 22 mm metal switch.

Choose an actuator and contact block to make your own 22 mm plastic switch.

Immediately cut power by pulling the cable.

Combine a push-button actuator with a switching mechanism to build a complete switch.

Small enough to fit in tight spaces, these circuit breakers mount through panels and are UL 489-rated for branch circuit protection.

Replace any Edison-base fuse with these resettable circuit breakers.

An electronic trip mechanism makes these circuit breakers fast, precise, and consistent. They continuously monitor current and trip at a precise value compared to the much wider current range in traditional thermal-magnetic breakers.