Push down on the spring-loaded drain plate to submerge and agitate to clean parts. The drain plate acts as a flame arrester in the event of a fire.

The cleaning solution is stored inside a drum to reduce fumes and solvent evaporation. Use these parts washers with solvent-based cleaning solutions that have a flash point above 105° F. Turn on the pump, and solution will flow to the flexible metal spigot. Washers have a filter that removes large particles to keep the solution cleaner longer. A fusible link closes the cover in the event of a fire.

Note: Do not use with flammable liquids.

Easily insert and remove parts from these cans. Good for small cleaning jobs, they save space and solution. A fusible link closes the cover in the event of a fire.

Sized for a benchtop, these washers are good for cleaning small parts. They have a flexible PVC hose with flow-though brush. Turn on the pump to circulate the solution. Use with solvent-based cleaning solutions that have a flash point above 105° F. A fusible link closes the cover in the event of a fire.

Note: Do not use with flammable liquids.

This type of solution is good for use in spray washers where foaming can be a concern. It can be heated to 140° for faster cleaning. Dilute with water to make up to 40 gallons of solution.

A dolly with casters makes it easy to move these parts washers around your facility. Turn on the pump, and solution will flow to the flexible metal spigot and polyethylene hose with flow-through brush. Washers have a filter that removes large particles to keep the solution cleaner longer and a heater to increase the cleaning power. A fusible link closes the cover in the event of a fire.

Note: Do not use with flammable liquids.

Turn on the pump, and solution will flow to the flexible polyethylene hose and flow-through brush. These parts washers have a filter that removes large particles to keep the solution cleaner longer and a 1.4kW heater with thermostat to increase the cleaning power.

Note: Do not use with flammable liquids.

Remove sticky excess resin from 3D-printed parts hands-free. Just fill these washers with isopropyl alcohol or another solvent and choose your resin’s wash time. In minutes, your parts will be clean. No need for time-consuming hand washing—an impeller automatically churns the solvent to get resin out of shallow holes and internal channels on your parts. Once washing is done, air- or fan-dry before curing.

If your parts were printed with a Formlabs printer, you don’t have to remove your parts from the build platform. Slot the full platform into these washers, and you’re ready to go. To prevent your parts from warping, they’ll automatically lift the platform out of the solvent once washing stops.

Clean small parts with these compact washers. Turn on the pump to circulate the solution to flow-through brush. Washers have a heater to increase cleaning power.

Note: Do not use with flammable liquids.

Use in bioremediating (also known as self-cleaning) parts washers. Microbes in the solution consume and destroy grease and oil to prevent it from building up in the solution. Dilute with water to make 19 gallons of solution.

Connect these washers to a water supply to rinse many pipettes efficiently, reliably, and safely. Place pipettes within the carrying basket, which cushions them to prevent breakage. After soaking them, transfer the basket to the rinser. The rinser fills with clean water to wash your pipettes and rapidly siphons out contaminated water to maintain cleanliness. All components are made of polyethylene or polypropylene to withstand common cleaning solutions.

Unlike other solvent-based parts washing solutions, these won't leave anything behind. They have a mild odor.

Note: Use only at room temperature; do not heat.

Leave a corrosion-resistant film on parts after washing. These solutions have a mild odor and contain no chlorinated solvents.

Note: Use only at room temperature; do not heat.

Clean faster by heating these solutions up to 140°. After washing, parts can be rinsed with water.