Use these tools to hold, separate, and position wire, springs, and other small parts.

Hold, separate, and position small parts with one tool. These sets include assorted picks with a different tip at each end.

A different tip at each end allows you to install, extract, and position parts with one tool.

The handles of these assorted picks have a magnet at the end to pick up small steel objects. Use to hold and position wire, springs, and other small parts.

Sets include a handle and an assortment of tips for holding and positioning wire, springs, and other small parts.

Avoid nicking or scratching sensitive components. These picks are good for adjusting small wires or separating press-fit plastic components.

Made of either plastic or wood, the picks in these sets won’t nick or scratch sensitive components or soft materials. Use them to hold and position wire, springs, and other small parts or to separate press-fit plastic components.

These assorted picks have insulated handles that protect against accidental contact with live electrical circuits. They are tested to 1,000 volts to meet IEC 60900 and ASTM F1505. Use to hold, separate, and position wire, springs, and other small parts.

An insulated handle protects against accidental contact with live electrical circuits. These picks are tested to 1,000 volts to meet IEC 60900 and ASTM F1505. Use to hold, separate, and position wire, springs, and other small parts.

Solder won’t stick to these assorted picks, which are used for positioning circuit board components. Sets include carbon steel picks that are wear resistant for long life. Copper brushes are softer and less likely to scratch metal surfaces, while stainless steel brushes are more abrasive and better for tougher cleaning tasks.

Made of beryllium copper that is FM approved, these picks satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present. They are also nonmagnetic. Use to hold, separate, and position wire, springs, and other small parts.

Warning: Do not use these tools in direct contact with acetylene.

Similar to dental instruments, these needle-sharp picks are suitable for work around delicate circuits and components.

Install, extract, and position parts around delicate circuits and components with the precision tip on each end of the picks in these sets. The needle-sharp tips are similar to dental tools.

A carbide tip marks hard materials such as hardened steel, stainless steel, and ceramics. It also lasts longer than steel tips on steel and plastics.

Use the steel tip on these scribers to mark steel and plastics, or as a pick for cleaning and probing. They have a knurled grip for a secure hold.

Mark steel and plastics or use as picks for cleaning and probing. These sets include a handle with four interchangeable points. The handle has a knurled grip for a secure hold and a hex-shaped handle that prevents rolling.

Also known as surface gauges, use these to scribe lines, transfer measurements, or as height and depth gauges. They have a V-groove base that can be used on round or flat surfaces.

Gauge pins can be pushed down for use against the edge of a surface plate or T-slot for linear work.

The angled tip and large handle make it easy to pry out cotter pins.

Install and position tiny springs and wires. Unlike conventional picks that have pointed tips, these are rounded to prevent damage to sensitive components.