Plastic pins are a nonconductive and nonmagnetic alternative to metal dowel pins. Use them as pivots, hinges, shafts, jigs, and fixtures to locate or hold parts.

Oversized to fit worn and enlarged holes, these pins work well as repair and replacement parts.

To remove these pins, thread a screw or tool into the tapped hole, then pull them out.

These pins make good hinges or pivots. The grooved half locks pins in position, while the smooth half can act as a pivot. Also known as type H pins.

These pins are commonly used as anchors for tension springs. The grooved half locks pins in position, and spring ends fit in to the notch. Also known as type G pins.

Use these as pivot or hinge pins. The knurled half locks pins in position, while the smooth half acts as a pivot.

Center-knurled pins are often used in place of clevis pins or to create T-handles. The knurled center locks pins in position, while the smooth ends act as a pivot.

These pins combine the locking capabilities of a clevis pin with the precision diameter of a dowel pin for a tight fit.

Install or remove these pins from either side.

Install or remove these pins from either side. Slide a retaining ring into the groove for a secure hold that takes up less space than a cotter pin.

For the fastest installation, push these pins into a hole and a spring-loaded wedge pops out to lock them in place. Also known as slic pins.

These pins have a low-profile head, so they won't get knocked out of place. A spring-loaded, nonlocking retaining ball pops out when the pin is pushed through a hole, and retracts when the pin is pulled out.

The smooth ring handle on these pins won't catch on parts. The shoulder keeps a portion of the pin outside the hole and makes them easy to grab.

For a more secure hold than standard quick-release pins, these pins lock in place until you push the button to release the spring-loaded retaining balls.

When there isn't enough room for a T-handle, an L-handle saves space but is still easy to grip. For a more secure hold than standard quick-release pins, these pins lock in place until you push the button to release the spring-loaded retaining balls.

A recessed button prevents accidental pin removal. These all-stainless steel pins stand up to corrosive environments. They lock in place until you push the button to release the spring-loaded retaining balls.

Also known as double-acting pins, these pins lock in place until you push or pull the handle to release the spring-loaded retaining balls. The T-handle is easy to grip.

A 60° beveled head fits into a countersunk hole.

Use these pins with a die to punch 1/8" and larger holes. Pins can be modified to fit your application.

Slide the pin through a hole then snap the ring down to lock these pins in place. Also known as click pins.

These spiral pins remain flexible after installation, so they absorb shock and vibration better than slotted spring pins. They work well in holes that are out of round.

Weld these pins directly to a surface —no mounting hole required.

These anchors are also known as drive rivets. To install, hammer the pin into the body. Pry out the pin to remove.

These anchors are also known as drive rivets. To install, hammer the screw into the body. Unthread the screw to remove.