These U-shaped supports allow access to pipe and conduit after installation. Use them to suspend pipe, tube, and conduit above the floor. To install, add an extension pipe (not included) that is approximately 4" shorter than the desired height. Tack weld pipe to the base and support, then bolt the base to the floor. Fine-tune the overall height using the adjustment screw.

Support lines that expand and contract. The roller on these supports compensates for movement in your line from changing temperatures. Often used outdoors, these supports are galvanized steel to resist corrosion in wet environments. Bolt them to the floor, beams, or brackets. They can also be welded into place.

Adjust supports to the exact height you need to route pipe, conduit, and tubing through strut-mount routing clamps and hangers. The wide base provides stability without needing to permanently secure to the floor. Supports have a 1 _5/8" wide strut channel for use with strut-mount clamps and hangers.

Bolt these supports directly to a pipe flange to suspend a run of pipe above the floor. Unlike clamps and hangers, which fasten to walls and ceilings, these supports mount to the ground. To install, add an extension pipe (not included) that is approximately 4" shorter than the desired height. Tack weld pipe to the base and support, then bolt the base to the floor. Fine-tune the overall height using the adjustment screw.

Reduce noise caused by HVAC systems. These sturdy rubber supports isolate vibration caused by heat pumps and air conditioning units, resulting in a quieter facility. When used on roofs, they also keep components above puddled water, which can cause damage. Supports have integrated strut channel that works with strut fittings and strut-mount routing clamps to organize and secure duct, pipe, tubing, and conduit.