When heat is applied, the insulation shrinks and creates a seal that keeps out water and contaminants. Also known as bullet terminals, these have a round tab that requires less space than the flat tab found on most quick-disconnect terminals. Use a crimper (not included) to install wire.

Female terminals have a fully insulated connection tab, so no metal is exposed when they are mated.

For technical drawings and 3-D models, click on a part number.

When heated, the enclosed solder in these terminals melts forming the most secure and electrically conductive connection we offer. The plastic insulation also shrinks when heated, sealing out water and contaminants. Also known as bullet terminals, these terminals have a round tab that takes up less space than the flat tabs on most quick-disconnect terminals.

Female terminals have a fully insulated connection tab, so no metal is exposed when they are mated.

For technical drawings and 3-D models, click on a part number.

Ready to install in panel boxes, switches, outlets, and other devices, these cords come with a spade terminal already attached to one end. No need to remove your mounting screw to install—just loosen it, slide the spade terminal in, then tighten the screw. These cords are made of stranded wire, which is more flexible than solid wire. They’re pliable enough to be pulled around corners and maneuvered in tight spaces.

Cords with wire leads carry a charge between electrical components, such as from a splice to screw terminal. They’re also known as non-grounding pigtails.

Cords with a ring terminal are also known as grounding pigtails because they create a grounding connection when you fasten the screw into a metal surface, such as the inside of a junction box.

For technical drawings and 3-D models, click on a part number.

Save preparation time—these cords are ready-to-use with ring terminals on each end of a single-conductor wire.

For technical drawings and 3-D models, click on a part number.