With a rounded, weighted base, these floodlights wobble—but don't fall over—when bumped.

Flood dark, remote jobsites with multiple tiers of light. These cordless lights stack on top of each other to focus a strong beam of light in one direction.

Brighten remote areas using the same battery as your other cordless Milwaukee tools.

Brighten areas of a jobsite with these floodlights, and move them at a moment’s notice.

Bring light to remote, wet areas. These floodlights are IP rated to handle humidity and dripping, splashing, and falling liquids. Adjust their tripod up and down to direct light as far as you need.

Our brightest plug-in floodlights, these lights illuminate large worksites—about the size of a hockey rink.

Aim light where it's needed most in areas that don't have an electrical outlet.

Because these lights are compatible with DeWalt rechargeable batteries, you can keep one type of cordless tool battery on hand. Their head pivots to aim light where it's needed in areas that don't have electrical power service.

Point light where it’s needed—even in wet areas. These lights are sealed against splashing and dripping water.

A series of bulb heads are attached to a power cord to provide overhead lighting for job sites.

A flexible design allows these lights to be suspended above, wrapped around, or routed through areas on the job site.

Hang these lights above your workspace—they shine through long tubes to distribute even light with minimal glare and shadows. Carry them where you need them and suspend them from pipes, beams, and other overhead surfaces.

Light up large, open rooms where you need a quick setup and takedown, such as a room under construction. Just hang these lights from a ceiling up to 30' high and they’re ready to go.

Light up damp areas—these lights seal out moisture and humidity. They’ll even work in areas with frequent washdowns. Rated NEMA 4X, they withstand spraying liquid, resist corrosion, and keep out dust.

Aim light where you need it—even in explosion-prone spaces—by raising, lowering, and tilting these lights on their tripod. Rated NEC Classes I, II, III, and Zone 0, they’re safe to use near ignitable concentrations of flammable or combustible gas, dust, or fibers.

Bring light to explosion-prone work areas. Rated NEC Class I, these lights are safe to use in areas with ignitable concentrations of flammable or combustible gases, vapors, and liquids.

Light up work without risking an explosion. NEC rated, these headlamps are safe to use in areas with ignitable concentrations of flammable or combustible gases, vapors, and liquids.

Light up work even when your visor is up. These headlamps come with three attachments that fit with anything from your hard hat to your baseball cap.

Light up work while staying visible in high-risk areas. These headlamps have LEDs on the head band so forklift and truck drivers can see you.

Small enough to fit in your pocket.

Made of stainless steel, these pocket-size flashlights have a smooth, easy-to-clean surface.

Always have a flashlight on hand—these attach to a key ring.

The handle opens into a tripod, so you can shine light on your work while keeping your hands free.

Light up objects more than a quarter of a mile away. These flashlights are also known as searchlights.

Tilt the head on these flashlights to aim light exactly where it's needed. They have a flat bottom, so you can work hands-free without them rolling away.

Shine light into hard-to-reach spaces—these flashlights have a flexible arm to see around tight corners and in crevices. They’re rated for use in environments where flammable gases, vapors, and liquids are present.

Clip these little flashlights to any surface up to 1/2” thick and keep your hands free for work. They’re rated for use in environments where ignitable concentrations of flammable or combustible gases, vapors, and liquids are present.

All of these flashlights stand up to wet environments.