A quick push is all it takes to actuate these switches.

A housing seals in anything that could ignite flammable material, so you can use these switches where explosive gas, dust, and fibers may be. They actuate with a quick push.

The built-in contact block in these switches extends behind the panel half the depth of most other 22 mm switches, saving valuable space.

A single-piece construction prevents the contact block from separating from the actuator in high-vibration applications.

Save space on your panel by using one switch for several tasks. These switches actuate with the push of a button.

Because these switches mount flush against a panel, they're easy to clean and hard to damage.

Because these switches mount flush against a panel, they're easy to clean and hard to damage.

Immediately cut power with a single push.

Sized for 4 mm or 6 mm panel cutouts, these switches are often used with circuit boards to control electronics.

The face of these switches mounts flush against a panel, so they're easy to clean and hard to damage.

Push the button to actuate these switches. Colored actuators help you tell switches apart without reading labels.

Send a signal from your circuit board with the push of a button.

Use these switches where ignitable gas and dust may be present. Their contact blocks are UL listed for Class I, Division 2, Groups B, C, and D hazardous locations.

Rated NEC Classes I, II, and III, these switches have a housing that keeps fire and sparks in, so they won’t ignite gases, vapors, or dust. To save space on your panel, they can control multiple circuits.

Install in 10 mm dia. cutouts.

A protective plastic enclosure resists dents, chips, and cracks, so you can install these switches outside of panels.

With a stainless steel enclosure, these switches are more durable than aluminum and plastic. They're rated NEMA 4X for protection from corrosion and washdowns.

Use these switches where ignitable gas and dust may be present. They're rated for use in hazardous locations.

These aluminum switches are rated NEMA 4, NEMA 13, and IP66 for protection from washdowns and oil/coolant spraying.

Often used to trigger alarms, these switches have a recessed button to prevent accidental activation. Mount under desks or in other discrete locations to avoid drawing attention.

Snap these switches onto your T-slotted framing rails—no need to drill or disassemble your existing structure.

Immediately cut power with a single push.

Choose an actuator and contact block to make your own 16 mm switch.

Choose an actuator and contact block to make your own 22 mm metal switch.

Control machinery from a safe distance, or use these switches as call buttons.

Control cranes and other mobile machinery in dirty, outdoor, and wet environments without damaging your switch.

A durable rubber housing covers the buttons and protects these switches from impact.

Never worry about your pendant switch losing power. These pendant switches generate enough power from pushing the button to send a signal to a receiver up to 330 feet away.

Operate equipment from up to 330 feet away—these switches include a transmitter and a receiver that connects to equipment.

Tug on the cable anywhere along your line to immediately cut the flow of power. This multi-functional unit also sends a signal to restart machinery with the push of a button, doing the job of two units in one.

Mount these breakers, also known as supplemental protectors, through panels downstream from a branch circuit breaker to protect a single piece of equipment.

Built to resist vibration and corrosion in harsh environments, these circuit breakers protect against overload and short circuits in low-voltage automotive and other electronic applications.

Protect against overload and short circuits in low-voltage automotive and other electronic applications.