You can use these lights outdoors and they will still be visible. Rated IP67 for harsh environments.

Lights have a watertight O-ring seal.

Easier to spot than other strobe lights, these lights emit bursts of multiple flashes.

Screw into a standard medium-base light socket.

Mounted on a tripod, these lights stand higher for greater visibility than other strobe lights.

Set these portable lights wherever you need a signal light—they don't need to be wired or plugged in.

As small as a hockey puck and compatible with standard 12-volt vehicle plugs, these strobe lights are inconspicuous when not in use and quick to connect.

Place these lights in full sun and their batteries charge during daylight hours. Lights automatically switch on at dusk and off at dawn.

These lights cycle through three different flashing patterns.

Direct your signal with these lights; they flash in one direction.

The pad below the base absorbs shock and vibration.

Carry these lights around with you and place them wherever needed.

The revolving motion of the light makes these more visible than flashing lights.

The buzzer warns workers of hazards even when they’re outside a direct line of sight.

The quick-connect four-pole M12 plug on these lights makes them easy to hook up and configure.

Use these lights in tight spaces in place of a tower. They emit three colors from a single lens.

Design a stack light with your choice of light pattern and color. Start with a base, then add up to five modules total—twist and lock them together.

Always know the precise status of your collaborative robot without complex wiring or custom programming. These lights come with a URCap plug-in, so your robot can communicate a range of conditions to them—from the end of a cycle to faults.

Get notified about equipment issues even when you aren't around your machines. These lights connect to your computer via Ethernet, allowing you to set up email alerts when there is a problem with a machine, server, or conveyor.

Use a computer to program colors, lighting patterns, and sounds to communicate a variety of status conditions, material levels, and cycle times—these stack lights have 21 colors and 11 sounds.

No hardwiring required—these backup lights plug into a standard outlet.

Installed in drop ceilings, these lights are often used in open workspaces where columns and walls are few and far between. Unlike traditional backup lights, they don’t require a vertical surface for mounting.

Light the path toward exits where combustible gases and dust are constantly present—the enclosure on these lights contains sparks and flashes to prevent a reaction with nearby hazards. They’re often found in extreme environments, such as refineries and chemical plants.

Install these lights in aircraft hangars, gas plants, and other facilities where flammable and combustible gases or dust may be present, such as leaks or ventilation failures. Rated NEC Class I, Division 2, they seal out gases but aren't built to contain explosions.

Clip these little flashlights to any surface up to 1/2” thick and keep your hands free for work. They’re rated for use in environments where ignitable concentrations of flammable or combustible gases, vapors, and liquids are present.

Tilt the head on these flashlights to point light where you need it in explosion-prone areas. Rated NEC Classes I and II, they’re safe to use where there are ignitable concentrations of flammable or combustible gases, vapors, liquids, and dust.

Aim light where it's needed most in areas that don't have an electrical outlet.

From pipes to pallet racks to control panels—these lights clamp onto almost anything and swivel to direct light just where you need it.

Bring light to areas that don't have electrical power service.

Keep excess cords out of your way—the reel locks the cord at any length and retracts it when not in use.

Light up large, open rooms where you need a quick setup and takedown, such as a room under construction. Just hang these lights from a ceiling up to 30' high and they’re ready to go.

A mounting clip at the base lets you attach these lights to nearby surfaces.

Light up damp areas—these lights seal out moisture and humidity. They’ll even work in areas with frequent washdowns. Rated NEMA 4X, they withstand spraying liquid, resist corrosion, and keep out dust.

A series of bulb heads are attached to a power cord to provide overhead lighting for job sites.

Flood hazardous areas with light—these lights are intrinsically safe, meaning they can’t cause an explosion or fire. Rated NEC Class I, II, III, and Zone 0, they’re safe to use in areas with ignitable concentrations of flammable or combustible gases, dust, and fibers.

Safely light up large spaces where combustible gases and dust are normally present. Rated NEC Class I and II, these lights have a housing that contains any sparks or flames and seals out ignitable gases, vapors, and dust.

Shine light into hard-to-reach spaces with these flexible-arm flashlights.

Clip these little flashlights to a baseball cap or a surface to light up your work.

IP rated for submersion, these flashlights keep working even if dropped in water. They run on a rechargeable battery, saving you the hassle of frequent battery swaps.

Always have a light handy. These flashlights use disposable batteries, so you can swap in a new set at any time without waiting for a charge.

Have light at the ready in the wettest conditions. These flashlights are IP rated for submersion, so they’ll keep working even if dropped in water.

When the power goes out, these flashlights automatically light up. The head tilts so you can aim light wherever you need it.

Instead of making frequent battery swaps, just plug these flashlights in to charge them.

Because these flashlights are buoyant, they're easy to recover when dropped in the water.

Our brightest plug-in floodlights, these lights illuminate large worksites—about the size of a hockey rink.

Light up remote spaces without having to keep track of a new cordless tool battery. These floodlights run on a Milwaukee M18 battery (sold separately). These lights extend up to 7 ft. tall and have a pivoting head to direct light where you need it.

Brighten remote spaces with the DeWalt rechargeable battery that’s already in your toolkit. These floodlights extend up to 7 ft., and the light head turns at any angle to aim light where it’s needed.

Compact and easy to carry, these ETL listed lights stand up to dripping, splashing, and falling liquids. The head adjusts up and down to direct light where it's needed.

Raise, lower, and tilt these lights to brighten your work in wet spaces.

Flood dark, remote jobsites with multiple tiers of light. These cordless lights stack on top of each other to focus a strong beam of light in one direction.

Illuminate small spaces and mark locations with these reusable lightsticks.

Light up work while staying visible in high-risk areas. These headlamps have LEDs on the head band so forklift and truck drivers can see you.

Light up work without risking an explosion. NEC rated, these headlamps are safe to use in areas with ignitable concentrations of flammable or combustible gases, vapors, and liquids.

Clip these headlamps right into a mount on your tactical or rescue helmet.

Light up drawers and enclosures where power isn’t available—these lights are compact and powered by battery.