These rods are precision ground and held to a strict straightness tolerance, so they're ready for turning in a lathe.

Precision ground and held to a strict tightness tolerance, these rods are ready for turning in a lathe.

Ready for turning in your lathe, these rods are precision ground and held to a strict straightness tolerance.

The thickness, length, and width are oversized for finishing to your exact requirements.

Hardened for increased abrasion and impact resistance, these rods are precision ground with a tight diameter tolerance.

With an oversized thickness, length, and width, these bars can be finished to your exact requirements.

Hardened for increased abrasion and impact resistance, these precision-ground rods have a tight diameter tolerance and are ready for turning in your lathe.

These rod sets are supplied in a metal index case with fold-out panels.

Ready for turning in a lathe, these precision-ground rods have a tight diameter tolerance and are held to a strict straightness tolerance.

Made from powdered metal, M4 tool steel has a consistent microstructure that gives it outstanding resistance to wear and abrasion. It is comparable to CPM Rex M4.

The thickness on these bars is precision ground to a tight tolerance.

All set for turning in your lathe, these precision-ground rods are held to a strict straightness tolerance.

Also known as flat stock, these bars have an oversized thickness, length, and width for finishing to your exact requirements.

The diameter on these rods is precision ground while the straightness is held to a strict tolerance, so they're ready for turning in a lathe.

This material has tighter tolerances than standard 303 stainless steel.

With a diameter that’s held to a close tolerance, this material is hardened for increased wear and abrasion resistance.

Precision ground on the top and bottom to a tight tolerance.

Precision ground to a tight diameter tolerance, these rods are all set for turning applications in a lathe.

Each piece is precision ground to offer tighter tolerances than standard 17-4 PH stainless steel.

Also known as Project 70+, this material machines faster with less wear on cutting tools than standard 17-4 PH stainless steel.

Eight times straighter than standard rotary shafts, these tight-tolerance shafts minimize vibrations and reduce wear to bearings and other components. They also have diameter tolerances that are twice as tight as standard rotary shafts.

In addition to diameter tolerances that are twice as tight as standard keyed shafts, these shafts include a traceable lot number and test report. Use them with machine keys to transmit torque to gears, sprockets, and other power transmission components.

Mount the flange to a machine or wall to support idler sprockets and pulleys in tensioning applications. They include washers and a nut to position your component and hold it in place.

Connect these internally threaded shafts directly to threaded components, or use a fastener to secure. They have a flat surface area that allows set screws to dig into the shaft for securely mounting gears, sprockets, and bearings.

The diameter of these shafts is slightly smaller than listed, so precision ball bearings (ABEC-3 and above) slide on without any tools.

Good for hydraulic systems, machine tools, and other high-torque applications, these shafts have teeth that transmit high rotational loads.

Clip retaining rings into the grooves to separate and position gears, sprockets, and bearings.